YWZ5-400/50 dust and gas industrial explosion-proof brake Hengyang Heavy Industry coal mine chemical plant use

The right way to open the hydraulic brake

　　How to use the hydraulic brake to effectively extend the service life of this product? How to not damage the product? Next hydraulic brake--Tianjin brake to give you a careful explanation of this knowledge, I hope you can help.

　　1. Often increase the lubricant in the movable part of the hydraulic brake.

　　2. If the worn braking surface is replaced, the to small gap between the braking surface and the turntable should be properly adjusted from the beginning.

　　3. Check the length of the armature stroke regularly. Because in the operation of the brake, because of the wear of the profile, the stroke length of the armature will increase. When the armature stroke length is not up to the normal value, it is necessary to make adjustments to restore the smallest clearance between the braking surface and the turntable. If the armature stroke length increases above the normal value, it may greatly reduce the suction.

　　4. Regularly check the mechanical wear and tear of the movable parts, and eliminate the dust, flower hair and dirt on the surface of the solenoid parts.

　　5 often check the bolt fastening degree, especially to tighten the electromagnet bolts, electromagnet and shell bolts, yoke bolts, electromagnet coil bolts and wiring bolts.

　　The above five points, that is, when we use the hydraulic brake, to pay attention to the points, and everyone in the use of this product is, must pay attention to its use, to avoid causing equipment damage.