Outline and dimension of ARCM200L shown in figure1:(unit:mm)

4.2  Installation method

Installation mode of ARCM200L type is embedded and the fixed mode is extruded, shown in figure 2.

 Figure 2

4.3 Wiring instructions(wiring is subject to the wiring diagram on the detector )

 4.3.1  Wiring method

Upper terminal: "12, 13" is the auxiliary power supply;"34, 35, 36" is relay output (DO1 is alarm output, DO2 is trip output);"24, 25, 26, 27, 28" is the on-off input;"21" and "22" are communications

J16 type wiring terminal:

Middle terminal: "53 ~ 64" is leakage current signal input (COM7, COM8, COM9, COM10 are not grounded)

4.4 Matters need attention

4.4.1 Connection method of residual current transformer

               Sheet 2

ATTN: as shown in the above table, when installing the residual current transformer, the N line and PE line must be strictly distinguished. In the three-phase four-wire system, the N line must run through the residual current transformer.The N wire passing through the residual current transformer shall not be used as PE wire, and shall not be repeatedly grounded or exposed to the conductor.PE wire shall not be used for residual current transformer.In TN-C system, the system must be modified to form local TT system, or transformed into TN-C-S system, and then connected according to the above table.

4.4.2 Auxiliary power supply connection

In combination with the above figure, when connecting the auxiliary power supply, the wire shall be made in the way as shown in figure 3. When making the wire, first press the wire head tightly, and then fix it with tin;The wiring is shown in figure 4. Insert it into the terminal row and tighten it with a screwdriver,to ensure the normal operation of the power supply.

4.4.3 Communication wiring

The device provides asynchronous half duplex RS485 communication interface, using modbus-rtu protocol, all kinds of data information can be transmitted on the communication line.Theoretically, up to 32 devices can be connected simultaneously on a single line, and each device can set its address and communication rate.It is recommended to use two core shielded wires with A diameter of no less than 0.75mm2, connected to A and B respectively. The shielding layer is connected to the ground or suspended at A single point. When wiring, the communication lines should be kept away from strong electric cables or other strong electromagnetic environment.

4.4.4 Sensor matching and installation

There are two kinds of external sensors, residual current transformer and temperature sensor, which are customized products and cannot be used to replace products of other manufacturers at will.When wiring, the secondary signal of residual current transformer does not distinguish the direction of current.

Contact Us

Jiangsu Acrel Electrical Manufacturing CO.,LTD

Contact nameTim

Chat Now

Phone86-1870-6168051

AddressJiangyin, Wuxi, Jiangsu

• *Email
  Please enter Your valid email address.
• *To

  

  Tim
• *Message
  Your inquiry content must be between 20 to 5000 characters.
•  

  Please enter a correct verification code.

Send Now