Professional Manufacturer Reasonable Price Flour Rotary Drum Dryer Biomass Rotary Dryer

Specifications

Professional manufacturer reasonable price flour rotary drum dryer biomass rotary dryer

Biomass rotary dryer 

Work site of biomass rotary dryer

Introduction of biomass rotary dryer

1.New type biomass rotary dryer with new type heat pipe structure, give material an indirect 

heated dryer.

2. Under the traction of hot air blower,enter and heating heat pipe,heat pipe heat transfer

to the material,due to material and heat pipe to full contact,so the drying out of material to

is better than common cylinder dryer's drying effect of the market.

3. The new type biomass rotary dryer's device enables real-time water vapor emitted from 

the top, and the end of the steam heat recovery and utilization, is a new type high efficient

energy- saving drying equipment.

4. New biomass rotary dryer has over 28 years' experience, independent of the development

and production of a new type of high efficiency energy - saving drying equipment.

5. Biomass rotary dryer uses heat pipe indirect to materials heating, materials and heat source 

to full contact, steam to real- time from the top of device , heat source use hot-blast stove 

heating not consumption, with dry effect good, and structure reasonable, and output big, 

and energy consumption low, and install convenient, and operation simple, and to range 

wide such as advantage of, is feed such as powder materials the most ideal private 

device.

Features of biomass rotary dryer

1. Within the device is composed of dozens to hundreds of heat pipes materials enter

from the top of the heating duct fell after drying the bottom of the device,get to the bottom

will be hot after shave plate scraped the bottom of the tube material keeps contact with

heat pipe to have a drying effect. This can greatly improve thermal contact area and

utilization of the material.

2. The device has wet discharging device in the drying process can be a result of discharge

large amounts of water vapor in the first time, the complete separation of water vapor drying

faster the lower heat loss, because it avoids the material in the process of drying and water

vapour exposure to eliminate the material may not be caused by repeated drying of moisture

absorption.

3.Tail of air circulator,we can heat reuse of tail up into a dryer really do make full use of heat

to achieve energy - saving effect.

Raw material of biomass rotary dryer

1) Wood sawdust, wood chip, wood shavings, etc.

2) Coal powder, coal slurry, coal waste, etc.

3) Clay, slurry, sand, silica sand, etc.

4) Grain, such as wheat, rice, etc.

5) Mash, diatillers, etc.

6) Animal dungs.

Structure of biomass rotary dryer

Biomass rotary dryer consists of seven parts: they are feeding hopper, heat source, rotary 

drum, lifting board, draught fan, unloader. 

Features of biomass rotary dryer

1. Large production capability, continuous operation

2. Simple structure, convenient operation

3. Low malfunction, low maintenance cost.

4. Wide scope of application, can be used to dry the granular materials, favorable for those

materials with the big adhesion.

5. Great operating flexibility, the output of the products allows a larger fluctuation range, not

influencing the quality of the products.

6. High thermal efficiency(≥ 60%)

7. Medium temperature in outlets(about700 degree)

8. Alloy steel plate or stainless lifting plate

9. Guaranteed drying effect (≤ 5% after drying)

10. Final biomass powder's humidity can be adjusted by adjusting its speed.

11. Far-ranging raw material: such as wood sawdust, wet sand, clay, coal, etc.

Main parameter of biomass rotary dryer

Customers came to our factory to check our biomass rotary dryer

Delivery site of biomass rotary dryer

Installation of biomass rotary dryer

♣ Fireplace is the place where the firewood, coal, gas or other material is burning for heat, 

there is a specially designed buffer which can make the hot air through but provent the fire 

in.

♣  Inlet place is beside the fireplace, thus the material can be dry at a early time.

♣  Roller is running evenly to make the material drying and processing at the same time.

♣  Discharging unit is installed with thermeter to control drying temperature. Temperature 

change of dryer's feeding end can be indicated by the thermometer to control the inner drier 

temperature ( generally 250-350°C)

♣ The cyclone is for the discharging, whcih is more convenient and air lock for making the 

discharging little noise and no waste.

If you are interested in our biomass rotary dryer, please contact:

In order to provide you the most suitable biomass rotary dryer, could you share me 

the following details? Thanks!

1) What's your raw material?

2) How many kilograms raw material do you want to dry up per hour?

3) What's your raw material's dimension?

Our factory:

Customer show

FAQ of biomass rotary dryer

1. What the biomass rotary dryer can be used for ?

Biomass rotary dryer can dry many kinds of granules materials which contain moisture, 

such as corn, grain, coal, coal slurry, slag, industrial waste, clay, sand, biomass powder,

cow dung, chicken dung, animal manure, grain, etc.

2. Is the biomass rotary dryer's heating source directly contact with clay?

Biomass rotary dryer's heating source can provide about 700-800℃, so it will be very 

dangerous if hot air directly contact the dry raw material powder. In order to avoide

this, our rotary sand dryer has designed a special equipment to avoide hot spark 

enters into rotary drum.

3. Can I use the coal or gas as the heating source?

Yes, you can use coal, gas, electricity, oil and wind power to heat the biomass rotary

dryer.