TRICONEX 9750-210F – Field Termination Assembly for Tricon SIS I/O

The 9750-210F is typically selected for safety, shutdown, and critical control where clean and reliable field terminations are non?negotiable. It’s a good fit for:

• Oil & Gas (ESD, F&G, compressor control, wellhead safety)

• Petrochemicals & Chemicals (BMS, SIS, interlocks, machine protection)

• Power Generation (turbine protection, boiler safeguards)

• Pharma & Specialty Manufacturing (validated safety loops and utilities)

• Metals, Pulp & Paper, and Water sectors with Triconex SIS deployments

• Reliability in TMR environments – Built for use alongside Triconex TMR I/O; seems to be a go-to choice when people want consistent wiring layouts.

• Lower project risk – Factory-matched TA helps reduce wiring errors during installation and speeds up loop checks in most cases.

• Maintenance-friendly – Clear channel mapping and service access shorten outage windows and minimize rework costs.

• Lifecycle continuity – Sticking to Triconex termination hardware simplifies spares strategy and eases future expansions or migrations.

Customer note: “We swapped mixed vendor terminal boards for 9750-series Triconex TAs, and loop checks went noticeably faster. Documentation lined up perfectly with the wiring—less chasing.”

• Cabinet environment – Install in a clean, dry, ventilated enclosure; maintain temperature and humidity per the Triconex system manual.

• Mounting – Panel or DIN-rail as specified; keep cable bend radii and clearance for terminal access.

• Wiring – Use ferruled conductors where possible; torque terminals to spec; segregate signal and power to limit noise.

• Grounding and shielding – Bond shields at the designated points; avoid ground loops by following project EMC practices.

• Safety – De-energize associated loops before working; verify isolation; follow site LOTO procedures.

• Routine checks – Periodically retorque terminals, inspect for discoloration or damage, and review channel labeling against the latest as-built drawings.

• Firmware – None on the TA itself; any updates occur on the Triconex controller/I&O modules, if applicable.

• Intended for use within the TRICONEX Tricon SIS platform, which is certified up to IEC 61508 SIL3 at the system level.

• Typical compliances for system components include CE and UL; RoHS compliance is common for current production, project-dependent.

• Manufacturer warranty is typically 12 months on new units; exact coverage may vary by supply channel and revision.

• Traceability via model and serial information; ensure the 9750-210F tag matches your BOM and I/O mapping before ordering.

Note: Specific channel count, fuse options, and connector style can vary by TA option and project standard. If you can share the paired I/O module part number and cabinet layout, I can validate the exact wiring map and mounting kit you’ll need for TRICONEX 9750-210F.