DS200VPBLG2A

This device can be directly placed behind the Profibus DP master station to convert a single cable bus into a redundant bus; It can also be placed in the slave station to convert redundant buses into non redundant cables, while also possessing performance such as optocoupler isolation and interference reduction. The product is an industrial grade design, IP30 protection level, corrugated aluminum reinforced casing, 35mm rail installation, DC (9-36) V wide power input, with advantages such as relay alarm output, dual power redundancy, and isolation protection.

Features:

*Supports predetermined communication rates in standard specifications

*Support manual setting of all standard rates or rate adaptation for dial switches (all electrical interface rates must be consistent)

*6 dual color LED status indicators, power failure relay output alarm

*Lightning protection for 4000V electrical interface, 1.5 A overcurrent, 600W surge protection. Industrial grade design, EMC testing certification

*DC9-36V wide redundant dual power supply, DC1500V power isolation, reverse protection

*IP30 protection level, corrugated aluminum reinforced casing, using standard industrial 35mm guide rail installation method

Performance indicators:

Data electrical interface:

*9-pin Sub_ The D-socket connector and pin definition comply with the protocol specifications of Profibus DP

*Supports the Profibus DP bus standard

*Communication speed: 9.6 kBit/s, 19.2 kBit/s, 45.45 kBit/s, 93.75 kBit/s, 187.5 kBit/s, 500 kBit/s, 1.5 MBit/s, 6 MBit/s, and 12 MBit/s

*Equipped with 4000V lightning protection, 1.5A overcurrent protection, and 600W surge protection functions;

*Terminal resistance: This device does not come with a terminal resistance, please connect it externally as needed

Power supply and protection:

*Power supply: Dual power redundant input, DC (9-36) V, typical DC24V, power consumption less than 4W, with DC1500V voltage isolation and reverse protection function, industrial terminal interface

*Relay alarm output: Link fault and power supply fault alarm output, contact capacity: DC48V/1 A, industrial terminal interface

Mechanical characteristics:

*External dimensions: 13