Grille Used Fiberglass Deck

We know that the grille cover is light weight, high strength and easy to install.During installation, the use of fiberglass grille greatly reduces the weight of the components, thus reducing the weight of the supporting structure. The installation does not require the use of lifting equipment, a small number of manual operations can be completed, both economical and convenient.So how to install after receiving the customized grille cover?Let's talk about it.First, glass fiber reinforced plastic grille plate cleaning the clean-up on site before installation, ensure that laid the ground clean and dry, and then the measurement and cutting materials, cutting work is simple, just use a manual cutting tools or a small electric cutting tools for cutting can, need to pay attention to is the place of edge and installation must be adequate clearance.Next, before laid grille cover board, want to be in laid bottom layer sprinkle on stick layer oil, after sprinkling, want to lay grille immediately.After carrying out laying artificially, want to pull grille segment tight, make grille longitudinal, transverse be in tense condition, roll with light road roller next one to two times, must decide grille cover plate below glass fiber reinforced plastics wants compacting mat flat.

When two cover plates are connected with each other, fiberglass fasteners and connectors of the same material should be used.When laying the grille cover plate, the longitudinal overlap shall be 20-30cm, and the transverse overlap shall be 8-10cm.Each longitudinal lap joint shall be fixed by steel nails and iron sheets. If the grille and the bottom layer are not well bonded due to various reasons, steel nails and iron sheets shall be used for sectioned fixation.If the user has requirements for the closure of the grid plate, you can buy the corresponding paste with the use.If the following problems are encountered during the installation of grille cover plate, corresponding measures should be taken immediately:

(1) in the asphalt mixture, because of the higher temperature factors, the paver and transport vehicles easy to take up the grid, therefore, asphalt mixture, prior to the spread of a small amount of stone dust.

(2) it is easy to stick the grille together when rolling with a roller. Therefore, during the rolling process, the roller must be used to spray water at any time while rolling.

(3) in the paving process, because of the large thrust, drive the grid to form a dozen, so, in front of the paver by two people at any time will dozen of the grille cover plate, and the grille width should not be too wide grille cover plate.

Cover plate has high heat resistance and excellent cold resistance, its maintenance work is very simple, only simple regular maintenance can, generally for some cleaning work.Above is the fiberglass grille cover plate installation and operation method, I hope to get everyone's a