CM30 20A 30A 12V/24V 48V solar charge controller

Place of Origin	Hubei, China		Brand Name	JUTA
Model Number	CM30		Application	Voltage Controller
Rated Voltage	12V		Maximum Current	30A

Specifications

LCD display 30A charge solar regulator
1. large LCD screen
2. working time auto set
3. 12V/24V auto switch
4. PWM mode

 

Installation

Install

1.    Ready tools and cables. Encourage you to matching the right cables. Ensure that the current density is less than 4mm²  that is conductive to reducing the line voltage drop. Recommended: 30A with 10mm² cable. Check weather the installation sites compliance with the relevant safety requirements. Please avoid the damp, dusty, there is a place flammable, explosive and corrosive gases use the controller to install.    

2.       Install the controller into a fixed vertical plane. See section 5 of the pore size and pore spacing. In order to ensure a good thermal control conditions, please set aside each 10cm below the controller space.

3.      As shown on the right, connect the (1) Load, (2) Battery and (3) Solar Panel to the controller according to the order of (1) (2) (3). Pay attention to the load, battery, solar panel and controller of same polarity.

4.     Put into the external temperature sensor on the left of the controller (probe port). The temperature sensor should be similar space with battery. (Otherwise, the controller will control the parameters of all wrong temperature compensation.)

5.      If you have remote monitoring and control function, please insert one end of the included communication wire on the right of the controller (communication port), the other end to connect to the host computer.

Demolition: To prevent accidents, please order the demolition of solar panels, battery and load disconnect with controller.

Note:Battery polarity will not damage the controller, but you will have a load equipm

 

 Technical Data  

Data            Model	CM2024Z	CM3024Z	CM2048	CM3048	Data           Model	CM3024Z	CM3048
Rated Current	20A	30A	20A	30A	Installation cable area.	≤7#  AWG  (16mm2)
Rated Voltage	12V/24V		48V		Operating Temperature	-10°C~60°C
Open Circuit Voltage of solar panel	≤50V		≤100V		Storage temperature	-30°C~70°C
Low Voltage Disconnection(LVD)	10.7V/21.4V		42.8V		Humidity requirements	≤90%,no condensation
Float Voltage	13.8V/27.6V		55.2V		Size	90 mm×188 mm×48 mm
Low Voltage Reconnection(LVR)	12.5V/25.0V		50.0V		Mounting hole spacing	60 mm×178 mm --Φ5
No load loss	≤30mA				weight	360g
Loop Voltage Drop	≤170mV				Notes	Model suffix “Z” represent automatic identify system voltage level, “T” represent controller with remote monitoring.
Charging Mode	PWM mode
Temperature Compensation	-4mV/Cell/°C