TFT1000M AGC 1000MHz 1310 nm Forward Optical Transmitter

Specifications

Summarize

TFT1000M Series optical transmitter is specially designed for CATV optical fiber transmission system, used for the transmission of simulation electrical signals. It uses standard 19 inches frame installation, just needs AC 220V 50Hz power supply, the only input signal is the transmitted RF signal.

Features

• adopt high quality high linear DFB laser module
• unique pre-distortion correcting circuit, fully guarantee excellent link performance
•  excellent APC (automatic power control),ATC (automatic temperature control) function, ensure  the stability of the laser output power and its long time work
•  high quality RF exciting circuit, lower RF exciting power requirements
•  high quality RF channel AGC control circuit, adapt to 72~82 dBuV (loaded 59 channels ) wide range of RF input signal
• high quality inserted type switch power supply, voltage range is wide, support double power thermal back-up
•  perfect protection circuit (boot time delay, working parameters alarm, RF excited too high,too low shut off alarm)
•  perfect LCD display control and RJ45 network management condition monitoring interface, built-in network management unit, support SNMP network management, can be convenient to monitor by local computer
•  excellent thermal design to ensure the equipment long-term reliability

Diagram 

Specifications

Remark 1: 1550nm wavelength optional is option, this loss value only aimed at 1310nm wavelength

Remark 2: C/N, CTB, CSO are all tested when meet the predict link(10 km above optical fiber). C/N is PAL-D within 550 MHz loaded 59 television channels; CTB, CSO value is the typical value when PLA-D loaded 59 channels in 550 MHz, the receiver's distortion contribution isn't counted.