ABB 086348-001 – Legacy DCS Module for Bailey INFI 90 System Sustainment

The ABB 086348-001 is a legacy control-system module used within Bailey INFI 90/NET 90 (Harmony) environments, typically as a like-for-like replacement to keep mature plants running safely and predictably. If you’re maintaining installed bases rather than migrating, this part helps you swap failing hardware with minimal disruption, fast.

From my experience, teams bring this in during planned turnarounds or to build a critical spare pool so one fault doesn’t turn into a long outage. It’s all about fit, stability, and keeping the control strategy unchanged.

• Genuine ABB part number (086348-001) – Specified for legacy Bailey INFI 90/NET 90 (Harmony) systems in many installed bases.

• Drop-in replacement – Typically installed 1:1 in the designated slot or mounting location per your cabinet drawings, without rewiring.

• Process continuity – Keeps logic, loop tuning, and operator graphics intact; no application re-engineering for like-for-like swaps.

• Lifecycle sustainment – Helps defer costly migrations while maintaining safe operation and spare-part coverage.

• Documented install practice – Compatible with standard Bailey maintenance procedures and test routines used across the series.

You’ll typically see ABB 086348-001 used for sustaining legacy DCS nodes in:

• Oil & Gas (midstream compression, refining units, offsite utilities)

• Chemicals & Petrochem (batch units, reactors, tank farms)

• Power Generation (balance-of-plant, water treatment, fuel handling)

• Pulp & Paper and Metals (wet end control, drives interface, auxiliaries)

One maintenance lead told us they swapped an 086348-001 during a short outage window, verified I/O health checks, and brought the line back without touching the control logic—exactly the sort of low-drama fix most teams want.

• Reliability – A like-for-like fit lowers the risk of unexpected behavior after replacement.

• Compatibility – Maintains your existing Bailey architecture, controllers, and termination hardware.

• Cost Avoidance – Extends asset life while deferring large-scale migration CAPEX.

• Maintainability – Works with established site procedures, spares strategies, and test tools.

• Support – Documentation and revision checks are straightforward when tied to the original part number.

• 
  

• Cabinet environment – Use in a dry, ventilated control cabinet; keep ambient within the typical 0–60 °C range, with clean power and proper grounding.

• ESD and safety – De-energize the cabinet or affected segment before removal/installation. Wear an ESD wrist strap and avoid flexing the PCB.

• Wiring & terminations – Match slot/terminal references to site drawings. If the module interfaces via a termination unit, verify terminal torque and shield routing.

• Revision check – Confirm hardware/firmware revision alignment with your controller and peer modules; this avoids nuisance diagnostics.

• Routine care – Periodically inspect for dust, loose connectors, or heat discoloration. If the function involves analog measurement, include it in loop checks and calibration schedules.

• 
  

• Manufacturing standards – Originally produced to ABB’s quality controls; many units were supplied into UL/CSA and CE-marked systems.

• Compliance – Certification markings may vary by vintage; verify against your site’s documentation if you require specific approvals (UL, CE, CSA).

• Warranty – For legacy spares, warranty terms typically depend on supply source and condition (new, surplus, or professionally refurbished). Many buyers standardize on 12 months for refurbished stock; we can align with your site policy.

•