Mitsubishi 10.4-inch touchscreen GT1275-VNBA

Mitsubishi 10.4-inch touchscreen GT1275-VNBA

Mitsubishi Touchscreen GT1275-VNBA

Built in 3MB standard memory

● Built in USB interface

Built in CF card interface with Ethernet port

Input power voltage

Input frequency

Input apparent power

power waste

100 to 240V AC (+10%, -15%)

50/60Hz ± 5%

44VA (4ms under load)

18W or less

15W or less

Below 40A (4ms under load)

Within 20ms (100V AC or higher)

Noise voltage 1500 Vpp, noise width 1 Ж s. Measure with a noise simulator, with a noise frequency of 25kHz to 60Hz

Apply 1500V AC between the power terminal and ground wire for 1 minute

Tested with an insulation tester, the impedance between the power terminal and the ground is greater than 10M Ω (DC 500V)

0.75 to 2 [mm2

resolving power

Display screen size

Display the number of characters

Display Color

viewing angle

brightness

Brightness adjustment

life

640x480 [Dot matrix]

211.2（W） × 158.4（H）[m] 170.9（W） × 128.2（H）[m]

16 point standard font: 40 characters x 30 lines (2 bytes)

12 point standard font: 53 characters x 40 lines (2 bytes)

256 colors

*2 Right/Left: 45 °, Above/Below: 20 °

200[cd/m2

]

4th gear adjustment

Approximately 52000 hours (operating ambient temperature: 25 ℃)

Cold cathode fluorescent tube (replaceable), 1 CCFL lamp

life

type

Keyboard size

Number of simultaneous touch points

life

C drive

Lifetime (number of writes)

*3

Over 50000 hours and over 40000 hours

(Time required for brightness to reach 50% at an ambient temperature of 25 ℃)

Analog

***Small 2x2 [dot matrix] (each button)

Do not touch simultaneously (only one at a time)

More than 1 million times (with a usage force of less than 0.98 [N])

6MB built-in flash memory

(Used to save project data and functional operating system)

100000 times

*4

1. Mitsubishi full series PLC, frequency converter, human-machine interface, servo system.

2. Xinjie PLC, frequency converter, human-machine interface and servo system.

3. Delta PLC, frequency converter, human-machine interface and servo system.

4. Wellington human-machine interface and Hytec human-machine interface.

Mitsubishi servo motor HG-JR15K1MB;

Mitsubishi servo motor HG-JR11K1MB;

Mitsubishi servo drive MR-J4-11KA

Mitsubishi servo drive MR-J4-11KB

Mitsubishi servo drive HG-KR-23J with oil seal

Mitsubishi servo store HG-KR053

Mitsubishi servo motor HG-KR73BJ with oil seal

Mitsubishi servo motor HG-SR102BJ with oil seal

Mitsubishi MR-J4-15KB servo driver

Mitsubishi PLC (programmable controller) A, R, Q, L, CC-LNK, FX3SA, FX3G, FX3G, FX3U, FX5U and other series;

Mitsubishi frequency converter A840, E840, F840, E740, D740, D720 series; Mitsubishi touch screen GT2000 series; Mitsubishi servo motor JE, J4 series.

Mitsubishi programmable controller: FX3GA, FX3GE, FX3G, FX3U, FX3UC, FX2NC, A, Q, CC-LINK remote module and other series

Mitsubishi variable frequency governor: FR-L700, FR-A700/500, F700/500, E700/500, D700/500, S500 and other series;

Man-machine interface: GOT2000, GOT16, GOT15, GOT12, GOT11, GOT10, A900GOT, F900GOT and other series;

AC servo system: MR-J4, MR-JE, MR-J3, MR-J2S, MR-E, MR-ES and other series;

Tension control system: LE-40MTA (B), LD-FX, LD-50PAU and other series:

Low-voltage electrical appliances: S-N, TH-N, etc.