Module spare parts IC698CPE040

Focus on DCS, PLC, robot control system and large servo system.

Main products: various modules / cards, controllers, touch screens, servo drivers.

Advantages: supply of imported original products, professional production parts,

Fast delivery, accurate delivery time,

The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands

v

RUN ENABLE Selects the source of the run enable signal. 0 = NOT SEL The ACS 140 is ready to start without an external run enable signal. 1...5 = DI1 ... DI5 To activate the run enable signal, the selected digital input must be activated. If the voltage drops and deactivates the selected digital input, the ACS 140 will coast to stop and not start until the run enable signal resumes. 6 = COMM The run enable signal is given through serial communication (Command Word bit 3). 1604 FAULT RESET SEL Fault reset source. Note! Fault reset is always possible with control panel. 0 = KEYPAD ONLY Fault reset is executed from the control panel keypad. 1...5 = DI1 ... DI5 Fault reset is executed from a digital input. Reset is activated by deactivating the input. 6 = START/STOP Fault reset is activated by Stop command. Note! This setting should not be used when start, stop and direction commands are given through serial communication. 7 = COMM Fault reset is executed through serial communication (Command Word bit 7). Code Description 19 PROGRAMMING Diagnostic Counters Diagnostic counters can be used for debugging the Modbus system. Counters will roll over from 65535 to 0. The counter values are stored to permanent memory when power is disconnected. Counters can be reset from the control panel by pressing the UP and DOWN buttons simultaneously when in parameter set mode, or by setting them to zero via the serial communication channel. Note! Parameters 5206 - 5212 are displayed in hexadecimal format by the control panel. The panel displays three decimal points to indicate a hexadecimal number. Figure 11 An example of the ACS 100 - PAN displaying a hexadecimal number A14 (2580 decimal). Code Name Range User Group 52 SERIAL COMM 5206 BAD MESSAGES 0 - 65535 5207 GOOD MESSAGES 0 - 65535 5208 BUFFER OVERRUNS 0 - 65535 5209 FRAME ERRORS 0 - 65535 5210 PARITY ERRORS 0 - 65535 5211 CRC ERRORS 0 - 65535 5212 BUSY ERRORS 0 - 65535 5213 SER FAULT MEM 1 0 - 3 5214 SER FAULT MEM 1 0 - 3 5215 SER FAULT MEM 3 0 - 3

1106 EXT REF2 SELECT

This parameter selects the signal source for external reference 2. The

alternatives are the same as with external reference 1.