F8650X

Brand: HIMA

Type:F8650X

Origin: Germany

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

The CI857 is powered from the processor unit via the CEX-Bus and requires therefore no additional external power source. Use the following procedure to install the CI857/TP853: 1. Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65 and Installing the PM86x/TP830 Processor Unit in Single Configuration on page 78. 2. Connect the Ethernet twisted pair cable to the COM1 connector on the baseplate (COM2 is not used for connection to INSUM). 3. Connect the other end of the Ethernet cable to the INSUM equipment via Ethernet/LON Gateway. Ethernet Twisted Pair Connection The Ethernet twisted pair is connected via the 10BaseT RJ45 connector located on TP853. For a description of the connector see Table 5 on page 84. Note that there is no unit redundancy for the CI857 unit.

The CI858 is powered from the processor unit via the CEX bus and requires therefore no additional external power source. The unit is mounted onto a horizontal DIN rail. Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65, Installing the PM86x/TP830 Processor Unit in Single Configuration on page 78 and CI858 and TP858 – DriveBus Interface on page 313. Optical Connectors The CI858 board connects to the drive system via three optical receiver/transmitter pairs. HP/Agilent Technologies Versatile Link Series (HFBR family) optical transmitter/receivers are used. Transmission speed of the optical fibres is 4 Mbit/s

The CI860 is powered from the processor unit via the CEX-Bus and requires therefore no additional external power source. Use the following procedure to install the CI860/TP860: 1. Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65 and Installing the PM86x/TP830 Processor Unit in Single Configuration on page 78. 2. Connect the Ethernet twisted pair cable to the COM connector on the baseplate. 3. Connect the other end of the Ethernet cable to Ethernet network via standard Ethernet components. 4. Please make sure to meet the FOUNDATION Fieldbus High Speed Ethernet specification of the network and the network devices. Ethernet Twisted Pair Connection The Ethernet twisted pair is connected via the RJ45 connector located on TP860. For a description of the connector see Table 5 on page 84.