Putty Powder Manufacturer, China Putty Powder Wholesale Wholesale Wall Putty Powder

Decoration wall powder, the first choice of Yao Wang bang!

Application of putty powder

Yao Wang Bang Putty Powder is a kind of building decoration material, mainly composed of heavy calcium, lime calcium, cement as a cementitious material and a substitute for glue.

But environmental friendly cellulose ether. Usually, the whiteness of putty is over 85 and the fineness is over 330. Putty is a kind of base material used for wall surface repair and leveling.

Lay a good foundation for the next step of decorating (painting and wallpaper). Yao Wang Bang environmental protection putty powder according to our current standards: JG/T 298-

2010 GB 18582-2008 production.

Product characteristics:

1, do not use glue directly mix with water can be used.

2. Compared with the traditional stone powder and glue batch wall, this product has formaldehyde-free, convenient construction, easy and free, strong adhesion, no cracking, no detachment.

Powder and surface are smooth and smooth.

3, green environmental protection, non-toxic, non irritating smell, no radioactivity;

4, moisture-proof, mildew, the longer the harder, not affected by climate.

Construction requirements:

1. Level off the wall surface. If the wall surface has oil, dust or other loose glue, it must be cleaned before construction.

2. Mix this product with about 2 parts of powder: 1 part of water (add water first and then powder), and put it for about 10 minutes.

3. The construction operation is basically the same as the traditional stone powder and glue batch wall construction, generally according to the bottom cover again, should not be scratched too thick, 1-2 mm for

Suitable, the first time to hit the bottom, the requirements of leveling, but also as thin as possible scraping, until the bottom is completely dry before covering, the effect is better. The cover is flatten about seven or eight.

Dry surface slurry does not stick to the hands with a scraper polishing 2-3 times, then the effect, can not wait for slurry to dry after polishing, otherwise it will affect the effect.

Matters needing attention:

1. This product can not be added to auxiliary materials (such as glue, white latex, cooked rubber powder, etc.), such as quality problems caused by adding, the factory is not responsible.

)

2, this product can not be directly distributed on gypsum board, silica board, splint, cement board and other non gray sand wall.

3. This product is stored in a cool and dry place. The shelf life is one year. If it is not agglomerated, deteriorated and can be used again after the shelf life, the quality will not be affected.

4, indoor refurbishment of old walls should be done on a small piece of experiment on the wall, if there is a phenomenon of yellowing, it is not suitable to use.