Hot Runner ABS PP Plastic Injection Mould Parts / Sub Gate DME Base

Quick Detail:

1. The part name: Automobile Parts? (plastic injection mold)

2. Plastic material: PP

3. Cavity material: H13 HRC48-52

4. Mold life: 1000k shots or according to customers quantity condition to decide it with saving cost for our customers.

5. Gate type: Hot runner to SUB gate according to our customers requires.

6. Mold base standard: LKM Local standard, DME or HASCO,Customize according to customers\' requirements

7. Standard of mold accessories: LKM, DME, HASCO, MISUMI, Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS, MOLD-MASTER, MERKLE, Parker, HPS, LKM, EUCHNER, RJG, cilpres, NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO JIS standard, PUNCH etc according to our customers requires.

Description:

The part name: Automobile Parts

Mold type: plastic injection mold

Part Material: PP

Locating ring Dimension: Ф3.99\",

KO Pattern: 7”x7”,

Sprue Radius: SR 1/2\"

Ejection type: ejection pin.

Mold construction description: Hot runner system, 2 plates, 2 sliders, there are 2 sliders in other sliders, there are some ejection pins in these sliders.

This part has very high appearance requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport,Sliver Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under dimension,Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE B-2.

This mould is made in Shiny Mould Factory. It is a mould exported to USA, with complicated structures and high quality requests. Customer needs mold life to be over 1 million shots. We can ensure this mold life and give warrant to our customer that once some mould components are broken during working, if it is caused not by the operation fault from the workers, we can provide new mould components to them free of charge.

Specifications: