Professional Custom Double Injection Mould SR 1/2" 1000k shots

Quick Detail:

1. Plastic material:PP+PP

2. The part name: Cosmetics lid (double color injection mold)

3. Gate type: Hot runner

4. Cavity material: S136 HRC48-52

5. Mold life: 1000k shots or according to customers quantity condition to decide it with saving cost for our customers.

6. Standard of mold accessories: LKM, DME, HASCO, MISUMI, Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS, MOLD-MASTER, MERKLE, Parker, HPS, LKM, EUCHNER, RJG, cilpres, NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO JIS standard, PUNCH etc according to our customers requires.

7. Mold base standard: LKM Local standard, DME or HASCO,Customize according to customers\' requirements

Description:

Part Material: PP+PP

Mold type: double color injection mold

KO Pattern: 7”x7”,

Locating ring Dimension: Ф3.99\",

Mold construction description: Hot runner system,double color injection mold

Sprue Radius: SR 1/2\"

Ejection type: ejection pin

The part name: Cosmetics lid

This part has very high appearance requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport,Sliver Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under dimension,Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE A-2.

This mould is made in Shiny Mould Factory. It is a mould exported to USA, with complicated structures and high quality requests. Customer needs mold life to be over 1 million shots. We can ensure this mold life and give warrant to our customer that once some mould components are broken during working, if it is caused not by the operation fault from the workers, we can provide new mould components to them free of charge.

Compared with traditional method of molding, advantages of two shot injection molding process are as follows:

1. The core material can use low viscosity materials to reduce injection pressure.

2. From the consideration of environmental protection, the core materials can use recycled materials.

3. According to the different use of characteristics, such as thick wall finished product cortex use soft material, the core material can use hard material or foamed plastic to reduce weight.

4. Low quality of core materials is helpful to reduce costs.

5. The cortex material or core material can use expensive material with special surface properties, such as material of EMI Shielding or high conductivity to increase product performance.

Applications:

Molding the plastic product by plastic injection machine

Specifications: