Semi-diameter Arced Concrete Column Formwork with 18mm Plywood / short Double-side V-iron

Semi-diameter Arced Concrete Column Formwork with 18mm Plywood / short?Double-side?V-iron

Descrition:

It?can?be?used?for?any?curved?wall?with?the?semi-diameter?longer?than?1.10m?

Adjustable?acted?Formwork?Profile?
Adjustable?Semi-diameter?Arced?Formwork?On?the?basis?of?the?foreign?company?technology,?we?developed?the?

Adjustable?Semi-diameter?Arced?Formwork,?which?can?be?used?for?any?curved?wall?with?the?semi-diameter

?longer?than?1.10m.?Traditionally,?the?formwork?is?produced?in?accordance?with?the?designed?semi-diameter,?

which?is?one-off?use,?causing?much?material?wasting.?All?the?defects?of?the?traditional?formworks?are?overcome?

after?we?developed?the?Adjustable?semi-diameter?arced?formwork.?Also,?we?lease?the?formwork?out?to?the?contractors

?to?save?their?cost,?which?proves?good?effect.?
Adjustable?acted?Formwork\'s?panel?is?18mm?Plywood,because?the?panel?specification?is?2440×1220?mm,so?the?formwork?

max?width?is?2440mmUpright?rib?is?combination?steel?frame?,the?panel?and?the?steel?frame?is?connected?by?bolt?;?

Horizontal?rib?is?short?Double-side?V-iron?,?there?are?adjustable?connectors?between?V-iron.Upright?side-rit?is?angle?steel?.?

The?radius?can?be?regulated?at?any?time?when?meet?to?different?section.????Adjustable?Acted?Formwork?Technique?parameter:?
?Allowed?Load50-70KN/M2???Per?square?meter65KG?
?
Advantage?of?the?product?
Can?be?adjusted?to?any?curved?wall?with?a?semi-diameter?longer?than?1.1m?
Easy?and?quick?operation.?
Low?cost?and?wide?use.?
High?standard?elements.?
?Assembly?procedure
1.?Assemble?timber?beam?and?timber?connector.
2.?Assemble?plywood?and?edge?rib.
3.?Assemble?adjustable?system.
4.?Assemble?connecting?waling.
5.?Adjust?the?formwork,?make?the?formwork?bent?into?designed?radius.
6.?Connect?every?module?by?adjustable?steel?clamp.

One?plan?sketch?is?shown?below