CT,CT-C Series Circulating Tray drying equipment

Specifications

Principle

        The product was upgraded and regenerated for several times and has reached to advanced level both at home and abroad. It uses steam or electric heater as heat resource and uses axial fan, heat exchanger to heat air in convective way. The laminar flow of hot air passes through the baking trays and will carry out heat transmission with material. Fresh air will enter into the oven from inlet to supply and then discharge from damp outlet. Fresh air is supplied, wet and hot air is discharged continuously. In this way, suitable RH in oven can be maintained. The ultimate advantage of oven is that most hot air is cycled in the oven, it increases heat transmission and saves energy source. It makes thermal efficiency of oven raise from 3-8% of traditional drying oven to about 35-50%. It uses the function of reinforced ventilation to decrease temperature difference from up to low. The oven delivered by our factory has set air distribution device. Before application, customer can adjust fan blade in order to make the temperature difference at the best state.

        CT series Tray drying equipment is not equipped with automatic control. It adapts 4-72 centrifugal fan. Model CT-C series oven adapts low noise high temperature resistant axial fan and also equips with automatic constant temperature control system, computer control system for customer's choice.

Applications

         This drying oven is suitable for the material and for the product hot solidification and drying de-watering in the pharmaceutical, chemical, food, farming, side-product, aquatic product, light industry, heavy industry and so on. Such as:raw material medicine, crude drug, prepared herbal traditional Chinese medicine, plaster, powder, particle, drinking agent, pill, packing bottle, pigment, dyestuff, de-watering vegetable, dried fruit piece, sausage, plastics, resin, electric component, baking varnish etc.

Explanation

         1. For the heating source, there are four kinds: steam, electricity, heat conducting oil, both steam and electricity.

         2. The temperature (steam heating) :50-140°C, Max 150 °C

         3. The temperature (electricity) :50-300°C

         4. The automatic control system or the computer control system is selectable.

         5. Commonly used steam pressure 0.2-0.8 MPa (2-8kg/cm²).

         6. If the electrical heating is type 1, the calculation is 15KW, and the practical use is 5-8 kw/h.

         7. The special requirements should be indicated at the time of order.

         8. The price for the non-standard oven should be consulted.

         9. The operation temperature is more than 140°C or less than 60°C should be indicated at the time of order.

        10. The oven and baking plates made by our factory are uniform in the dimensions, and can be exchanged each other.

        11. Baking plate dimensions 460*640*45mm

Specification

        The radiators can be used for various drying equipment. There are many specifications and kinds. The materials to be used are aluminum alloy stainless steel, A3 steel surface zinc covering, steel and aluminum compound, copper, steel pipe and aluminum winding sheet. In addition, the radiators can be used for heating and dehumidification indoors and in the warehouse. Our factory can carry out the design and manufacturing for our users.

1. Operation temperature: 50-400°C.
2. Being adapted far infrared quartz tube as heat radiation element, its heat efficiency is high and its condition of health is good.
3. Being adapted heating between layers, its difference in temperature is small and its time of sterilization is short.
4. There are 16 pieces of shaped baking pan inside the oven (640*640*45mm)
5. Non-standard size can be referred to the requirements of customers to make the front door and back door.

Process Chart

Technical Parameter