HUAHONG New Type and Good Quality Lead Edge Runner Wet Pan Mill to SUDAN

Introduction

The wet pan mill is a new mill, small investment, high yield, the production cost is low, good benefits.Thewet pan mill is named by the diameter of roller. Φ1300,Φ 1350,Φ 1400,Φ 1500,Φ 1600 is suitable for selection of iron ore, molybdenum ore ,lead ore ,zinc ore, antimony ore and so on. Φ 850, Φ 900, Φ 1000,Φ 1100,Φ 1200 is suitable for selection of gold ore.

Application

Mainly used with gold, silver, lead, zinc, iron, molybdenum, copper, antimony mine, mine, all ball mill can be selected grind gold machine can be used. Characteristics: grind gold through the raw material mixing, rolling, crushing, rolling repeatedly reach moisture equilibrium ratio of uniform, low gas content, improve the forming rate and forming quality, grind the material through the machine molding Products with high density, good strength, no porosity ratio weight. Energy efficient, high volume of output, the product is used for iron ore process tailings recovery, not to slag the loss of effective resources can be fully utilized.

Wet pan mill advantages

Main advantages of such conical mixing grinding pan mill are: Increase the weight of grinding wheel, simultaneously reduce lifting surface area.After grinding wheels rotation, the intensity of pressure on minerals increases, reaching the purpose of increasing output(not less than 150t per 24hrs)

On the basis of original equipment,a scraper device is added tadded to keep material layer 4-5 cm.Only under this state,swaging effect is excellent.In addition,fine material can be quickly cleaned away from mill groove.

Gold method for grinding machine:

The first step: after the installation and commission of gold grinding machine, then putting 1 kg mercury into the bottom, then the machine begin to work. 

The second step: every time collecting one time gold sand, when change , adding 5kg mercury into the bottom in order to collect gold sand and mercury of bottom, the place the mercury into the equipment which for collecting gold, then using a relatively high density of red cloth to wring mercury out, and open the red cloth the rest is gold sand

in the shift join five kilos of mercury charge roller, the bottom of the sands and mercury, the mercury receive into gold equipment, used a relatively high density of red cloth to mercury forced wring it out, and then open the red cloth which left is the golden sand.

The use and maintenance ways of wet pan mill:

1, after the machine works normally, starting feeding.

2, this machine is prohibited to work with material, if the machine stop , you must first clean the residual ore in the middle of mill groove and start again.

3, feeding should be uniform, not suddenly more and less, it is best to use the feeding machine.

4, bearing parts often needs to add butter, reducer must be constantly check whether the loss of gear oil.

5, often check the screws are loose or not

6, If you found that the bearing damage, must replace it in time, so as to avoid damage to other parts of shaft eccentricity

7when gold grinding machine operate, people should note that reducer or bearing parts have  abnormal sound, the temperature is too high, the motor current is too large, if the above phenomenon, people should immediately stop out.

8, when overhaul the machine,  ensure the safety, people must remove the motor belt.

The  main parameters Gold grinding machine

Clients visit our factory :

Clients test the gold grinding machine :

Clients pay the deposit:

Our product delivery to foreign country 

Picture about New Gold Grinding Machine :

Smooth surface design to avoid the small gold enter into the grinding roller and grinding pan.