Automatic Powder Coating Booth

MONO-CYCLONE TYPE POWDER COATING BOOTH WITH AFTER FILTER

WORKING PRINCIPLE

Consists of powder booth, cyclone group and after-filter system. The system is connected with each other air ducts. Base of the booth is inclined along the cabin at the bottom, allowing the powder to be sucked easily by the air movement created by the suction fan. Paint particles are collected in the cyclone tank, smaller particles goes into the after-filter unit. Coating collected in the cyclone can be reused again. Particles collected at the after filter unit cannot be used due to small particles collects here and cannot be charged electro statically.

CYCLONE

Powder coating particles moving by the ventilator suction movement enters the cyclone using air ducts and collects in the powder tank as a result of friction and gravitational force. In this systems powder is recycled at the cyclone tank where can be recovered manual or automatically.

AFTER-FILTER UNIT

Suction fan is mounted at the end of system, located on the after-filter unit in an insulated cabin that maintains minimum level of noise. Air movement generated by the fan brings smallest powder particles here that are filtered in this unit. Filters are cleaned as a result of the automatic cleaning system consist of solenoid valves and pressurized air system located here. Finally clean air is given back into the workshop area.

ADVANTAGES

Fast and easy color change

Efficiency 97%