Perfect protection security display stand for camera

Camera Security display holder with Alarming and Charging 

It is the most innovative security alarm display system.
  1) Prevent your displaying electronics from stealing
  2) It's convient for the customers to see camera ,mobile phone in the exclusive shops, etc.
  3) With the connection of the electronics to the display shelf, security display holder can
realized immediately while removed.

  4)Charging and anti-theft alarm for camera share one line

PERFECT Alarm Function
The security alarm display holder will alarm when it happens by any way of the follow:
  1) Circuit break resistance
  2) Short circuit resistance
  3) Other circuit-replacing resistance
  4) Prying and cutting resistance
  5) Remove the sensor
  6) Cut the spring wire
  7) Put out the connector
  8) Put out power connector- alarmabove 5 minutes or more long,according to customers'
requirement

 9) When remove or pry the stand on the bottom, the anti-theft function also can be available.

Operation steps:

1.) Charge for the holder with the adaptor connected (one edge of adaptor plunging into DC hole, the other edge connecting to power socket) (Led indicator turns red when charging and turns off when fully charged)

2.) Turn ON the button at the bottom of the holder

3.) Activate the holder by pressing the button on the controller, which should be aligned with Signal receiver hole within 15mm ( a prompting sound would be emitted when being activated )

4.) Tear off the 3M sticker at the bottom of the holder

5.) Stick the holder on clean desktop(lasting for more than 10 seconds)

6.) Make the display commodity locked on the top of the holder using a screw(lasting for more than 10 seconds)

7.) Tear off the sticker on small touch

8.) Make the touch adhered to the front face of displayed

Alarm solution  
when alarm,the green indicator light will turn red immediately.Use the remote control to
send signal to the host, within 15mm, press “lock”, and the host indicator light turn
green.

Alarm test
Using remote control to send signal to host, within 15mm, press “lock” ,and the host
indicator light turn green, then press “test” to alarm. Press “unlock” to finish

alarm test.