Security Display Stand Holder SLR Digital Cameras Anti-theft Display Stand

Specifications

Security Display Stand Holder SLR Digital Cameras Anti-theft Display Stand

Component:

1. Security display stand.

2. an adapter.

3 a decoder matching several holders.

4 a piece of specification.

5 a screw.

6 a bundle.

 Notes:

1. Keep the controller at a shorter distance with the Signal receiver hole (within 10 mm)

2. Avoid irradiating the Signal receiver hole by strong light

3 make sure the surface is clean before sticking

4 Please use it after 24 hours after 3M sticker works

5 The continuous flashing of Led indicator and the intermittent prompting sound indicate low power of the holder, which should be charged.

6 Alarming will last for 4 minutes in a time

7 Before replacing the 3M sticker at the bottom of holder, you should use a blower heating the area around where the holder bottom and desktop were adhered, thus weakening the adsorption property and easier to separate.

8 Code-rewritten is needed when LED indicator was lost or should be replaced for some reasons

9 you can rewrite code in the following two situations:

 1. Repeat the steps as above that you can once to write code for the Holder.

 2. You can make the holder out of alarming detection state and then rewrite code if holder adhered to desktop tough and hard to separate.

For example: Pull out the Crystal Head on the side face of holder and the holder is out of alarming detection state.