SMT Power Inductors with Low DCR and Large Current

SMT Power Inductors with Low DCR and  Large Current  Description

• Appearance inspection: no external defect by visual inspection
• Terminal strength: after soldering, between copper plate and terminals of coil, push in two directions of X, Y with standing as below conditions
• Terminal should not peeled off
• Heat endurance of re-flow soldering: 240°C
• Insulating resistance: over 100MΩ at 100VDC between wire and core
• Dielectric strength: no dielectric breakdown at 100V DC for one minute between wire and core
• Operating temperature: -20 to +85°C (contains heating coil)
• Temperature characteristic:
  • Inductance coefficient: (0 to 2,000) x 10 to 6, (-25 to +80°C) inductance deviation within ±5.0%, after 96 hours
  • Humidity: 90 to 95% relative humidity at 40 ±2°C and one hour drying under normal condition
  • Inductance deviation within ±5.0% after vibration for 1 hour
  • Vibration resistance: each of three orientations at sweep vibration (10 to 55Hz) with 1.5mm amplitude
  • Similar to coil craft and Toko, Sumida, TDK and Murata brands

HuBei ChuangSiNuo Electrical Technology Corp.,(CSN) -Electromagnetic Export

CSN was founded in May 2000, covering more than 12,000 Square Meters , holding more than 30 sets of automatic CNC machines and around 200 employees, CE & Rohs & ISO approved products:  Solenoid(s), solenoid valves, needle selector, coil, inductors solenoids. CSN can provide you OEM & ODM production baded on professioan and exprienced internatonal trade practice

Air Induction Coils Series:  widely applied to Sensors, IC card, Card readers, Wireless Chargers, Controllers and

etc.