Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine

Be Part Of The Solution  

  Not The Pollution        

About JNC SERIES Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine

JNC SERIES Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine can be used in different kinds of black engine oil,crude oil,plastic oil and shale oil,to get diesel and gasoline through distilled catalyst.

Pump  the waste oil into the heater,and heat it to its working temperature via coal or fuel oil,gas.

The maximum working temperature is about 410 degrees.

The required diesel and gasoline can be obtained after catalytic distillation.

When the reaction of waste oil in reactor is complete,the machine will stop heating automatically,after that we can just remove the residue from the bottom of the tank and then it can be used again.

SYSTEMS OF JNC SERIES Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine

Reaction tank:waste oil will be pumped into this tank from the primary filter

Heating system: by burning coal or fuel we can work the oil temperature up to setting value.This system equips with insulation system as well.

Catalytic system: waste oil reaches the expected temperature,via catalytic effect,and the gaseous hydrocarbons become gasoline and diesel compositions.

Cooling system: after the catalytic effect,the gasoline and diesel compositions will be condensed into liquid materials.

Temperature control system: to make sure the waste oil transformed into gasoline and diesel.When the waste oil is dried by distillation,it can stop heating timely.

Tail gas handling system: through tail gas system,a small amount of unliquefied gas left can meet emission standards.

THE RECOVERY OUTPUT RATE OF JNC Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine

Diesel:  86%-88%

Gasoline:  5%-6%

Oil Residue:  6%-8% ( which can be used as bitumen,the raw material for cement and bricks or heating fuel just as coal,after being cooled off to normal temperature )

REFINED OIL COMING OUT OF JNC Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine

MAIN BENEFITS AND ADVANTAGES OF JNC SERIES Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine

1 Working principle: waste oil under the action of catalyst distillation gets high quality diesel directly.

2 No need of acid,alkali,or activated clay to refine the final diesel, just use our plate-and-frame filter( carried with JNC) to remove the impurities.

3 Directly heating with fuel or gas, which is safe, convenient, practical, and environmental-friendly.

4 The total cost of processing used oil is only USD21 per ton (including fuel, electricity and catalyst cost).

5 Oil Output Rate: diesel 86%-88%,gasoline 5~6%,oil residue 6~8%.

6 Different from other equipment on the market: JNC Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine uses a special way of heating with high thermal efficiency so that it doesn’t form carbon deposition easily, which greatly reduces your maintenance costs.

7 Currently on the market, the distillation is based on coil heating, due to the temperature which can’t meet the technical requirements, the oil yield only achieve to 65%.

This kind of heating mode will make it easy to scale. More importantly, it needs high temperature pump which is expensive and easily breakable. These weaknesses mean you need high cost of frequent replacement after.

8 JNC Waste Pyrolysis Oil Distillation and Regeneration to Diesel Machine is safe, reliable and very durable. And it’s easy to operate and low on labor intensity, only 1-2 workers are enough to make the machine work.