Z-wave Gen5 Door/Window Sensor, white

Introduction 

This device is an accessory of the Z-Wave system and enable detection of opened or closed access locations in your home. ZW101B is a wireless, battery powered sensor, its two parts the sensor's body and a magnet separate. 

Technical data 

*Detects when your door/window is opened or closed
*Magnetic separation trigger function
*Hidden tamper prevention Trigger
*Low battery detection
*External Switch
*LED Status Indicator
*Battery Operation: ER14250*1pc (not include) 

*Operation gap: 30mm 

*Range: Min 30m line of sight 

*Operating temp: 0~40 ℃
*Working Voltage: 4.5V
*Dimensions(L*W*H): 7.6(L)*1.73(W)*1.9(H) CM 

*Net Weight.: 30g 

*Frequency: 868.4MHz/865.2MHz/869.2MHz/908.4MHz/921.4MHz

Installation 

1. First, add ZW101B to ZE200 controller or others, it must be in range of the controller, because the procedure of add to the ZE200 requires direct communication with the controller.

2. Set controller to “Add” mode, quickly pressing learn switch1 second at least & release to be included (the button is also the anti-packing switch).

3. After correct “Add” it to ZE200 controller it will be signaled by ZE200.

4. For “Remove” from a network: set up the Z-wave interface controller into “Remove” mode, and following its instruction to delete the ZW101B from your controller. Press the learn switch of ZW101B for 1 second at least &release to be excluded.

5.Use double EVA or screws to fix ZW101B on the Door/Window two sides, pls. be note correction position of the sensor and the magnet (dot-to-dot).

6.Re-setting ZW101B: Remove the battery, touch the senor’s body with magnet,re-install battery, trigger ZW101B one time, and reset will be confirmed by LED blink.