Zwave shocking sensor for home automation, white

This device is an accessory of the Z-Wave system and enable detection of opened or knocked access your casement window /door in your home. ZW105 is a wireless, battery powered sensor, its two parts the sensor's body and abuzzer connected.

Technical data 

*Detects when your casement door/window is opened or breakdown      
*Low battery detection
*External Switch
*LED Status Indicator
*Battery Operation: AAA * 3pcs (battery life 1 year)

*Range: Min 30m line of sight

*Operating temp: 0~40 ℃
*Working Voltage: 4.5V
*Dimensions(L*W*H): 78*42*16mm

*Frequency:868.4MHz/865.2MHz/869.2MHz/908.4MHz/921.4MHz

Installation

1. First, add ZW105 to ZE200 controller or others, it must be in range of the controller, because the procedure of add to the ZE200 requires direct communication with the controller.

2. Set controller to “Add” mode, quickly pressing learn switch three times (the button is also the anti-packing switch).

3. After correct “Add” it to ZE200 controller it will be signaled by ZE200. 

4. For “Remove” from a network: set up the Z-wave interface controller into “Remove” mode, and following its instruction to delete the ZW105 from your controller. Press the learn switch of ZW105 for 1 second at least &release to be excluded. 

5.Use double EVA or screws to fix ZW105 on the Door/Window two sides, pls. be note correction position of the sensor and the magnet (dot-to-dot). 

6.Re-setting ZW105: Remove the battery, touch the senor’s body with magnet,re-install battery, trigger ZW105 one time, and reset will be confirmed by LED blink.