Meanwell 600W battery power supply/600W Single Output Battery Charger Switching/48v mean well switching power supply

MODEL

PB-600-48

OUTPUT

BOOST CHARGE VOLTAGE

57.6V

FLOAT CHARGE VOLTAGE

55.2V

RECOMMENDED BATTERY

CAPACITY(AMP HOURS)    Note 3

35 ~ 105AH

BATTERY TYPE

Open & Sealed Lead Acid

OUTPUT CURRENT (Typ.)

10.5A

INPUT

VOLTAGE RANGE  

90 ~ 264VAC          127 ~ 370VDC

FREQUENCY RANGE

47 ~ 63Hz

POWER FACTOR (Typ.)

0.95/230VAC         0.98/115VAC at full load

EFFICIENCY (Typ.)

89%

AC CURRENT (Typ.)

6.8A/115VAC       3.4A/230VAC

INRUSH CURRENT (Typ.)

25A/115VAC         50A/230VAC

LEAKAGE CURRENT

<3.5mA / 240VAC

OVER VOLTAGE

64.5 ~ 69.5V

Protection type : Shut down o/p voltage, re-power on to recover

OVER TEMPERATURE

Protection type : Shut down o/p voltage, recovers automatically after temperature goes down

FUNCTION

REMOTE CONTROL

Open: Normal work         Short: Stop Charging

LEAKAGE CURRENT FROM BATTERY (Typ.)

1mA

FAST CHARGE

2 / 3 / 8 stage selectable

CHARGING OK

Relay contact (RY15)

OUTPUT OK

Relay contact (RY13)

TEMPERATURE SENSE

By NTC

ENVIRONMENT

WORKING TEMP.

-20 ~ +60°C (Refer to derating curve)

WORKING HUMIDITY

20~90% RH non-condensing

STORAGE TEMP., HUMIDITY

-40~+85°C, 10~95%RH

TEMP. COEFFICIENT

±0.05%/°C(0 ~ 50°C)

VIBRATION

10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes

SAFETY&EMC

(Note 2)

SAFETY STANDARDS

UL1012, TUV EN60335-1, EN60335-2-29 (except for 48V),

EN60950-1(48V only) approved

WITHSTAND VOLTAGE

I/P-O/P:3KVAC     I/P-FG:2KVAC     O/P-FG:0.5KVAC

ISOLATION RESISTANCE

I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC/25°C/70% RH

EMCEMISSION

Compliance to EN55022 class B (CISPR22), EN61000-3-2,-3

EMC IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024; light industry level, criteria A

OTHERS

MTBF

135.6K hrs min.    MIL-HDBK-217F (25°C)

DIMENSION

230*158*67mm(L*W*H)

PACKING

2.2Kg; 6pcs/14.2Kg/1.76CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets

EMC directives.

3. This is Mean Well's suggested range. Please consult your battery manufacturer for their suggestions about maximum charging current limitation.

4. Please choose the "3 stage" selection when the charger is used to charge the batteries and power the loads in the same time.