5kV 100mA ac/dc Withstanding voltage tester hipot tester high voltage test CS2672CX

Excellent Performance

1.  High voltage, low current, accuracy measuring

2.  Continuous setup of leakage current and test time, good adaptability

3.  Display tested real values simultaneously (time, voltage, current), and audible and visual alarm with disqualification

4. High voltage breakdown protection

The instrument can serve several purpose, for example, output current of DC port can realize the test of withstanding voltage and leakage current of capacitor, reverse voltage and reverse leakage current of high-voltage silicon stack and transistor, etc

The difference between CS2672B/C and CS2672BX/CX:

1. Time display

Three digital tubes display, the maximum test time can be up to 999s, the minimum time is 0.1s.

(CS2671AX/BX)                (CS2671A/B)

2. Time pre-set

For CS267Xseries, press the up or down key to increase or decrease the time pre-set value; While CS267 series need to press the time dial.

Time pre-set

(CS2671AX/BX)                      (CS2671A/B)

3. Time count method

For CS267X series hipot tester, if the time pre-set is set to 0, the tester will count up the test time; if the test time is not set to 0, then the tester will count down the time. (For example, if the test time is set to 60s, then the tester will do the test until the time is count down to 0)

For CS267 series hipot tester, if the timer switch is off, the tester will not count the test time.

4. The output high-voltage indicator

For CS267Xseries hipot tester, there is a danger indicator on the front panel. The high voltage indicator will light as long as there is high voltage in the high voltage output terminal. The indicator is not controled by the main circuit, which protect the operator.

5. PLC interface

9-pin PLC interface, can control the test, reset, under testing, fail(alarm), pass signal remotely. The contact signal is stable and easy to capture. The previous CS267series PLC signal is pulse signal(Pass), is difficult to capture the PASS signal.  

Technical Parameters

Test accessories

1. Remote test probe for withstanding voltage test

2. Test leads with clip for withstanding voltage tester

3. Power cord( European form, U.S. form is selectable)

 CE CERTIFICATE