Underground Mining Equipment

Specifications

Jaw crusher pre-start checks whether the ore crushing cavity or other debris should be removed immediately. Jaw crusher before starting guards should carefully check is good, found to be unsafe, should immediately eliminate it.After Underground Mining Equipment start, if found to have unusual circumstances, should be immediately stopped, the reason to exclude risks to be identified before they start again. After XINGHAO Underground Mining Equipment normal operation before feeding. Be crushed material should be uniform to join the crushing cavity, and should avoid feeding side, to prevent the sudden increase in load mutation or unilateral. After XINGHAO Underground Mining Equipment normal operation before feeding. Be crushed material should be uniform to join the crushing cavity, and should avoid feeding side, to prevent the sudden increase in load mutation or unilateral of Underground Mining Equipment

Bearing areas are the most vulnerable components, because it is in use, wear large need for regular maintenance, regular oil to increase bearing life. Machinery and equipment should be grounded, insulated wire should be reliable, and packed in snakeskin, always check the electrical wiring for wear and leakage.

Features

Underground Mining Equipment Long Service Life, Adjustable Final Size, Large capacity, Low Cost Spare Parts,

Underground Mining Equipment Operation Notes:

Regularly check the machine off Jaw Crusher stone crushing equipment at any time to switch the machine off should pay attention to regular checks Jaw Crusher wear inside the machine, such as the center of the feeding tube, cone hats, the impeller, obscene Road liner, circumference guard, wear wearable pieces of a more serious immediate replacement of worn parts to repair these parts at the same time pay attention to the weight of replacement parts, such as certain types and sizes according to the parameters of the original replacement parts.. Steel jaw crusher requires large furnaces for melting the steel mold casting. Now basically used electric furnace, the higher the production process. General by a professional casting plant jaw crusher housing body processing.

Maintenance & Attention

Moisture content of the material will affect the choice of the crusher, when excessive moisture, fine materials due to increased humidity will agglomerate or stick to the coarse-grained material, thereby increasing the viscosity of materials, reducing the rate of discharge, so that productivity declined. Serious, or even cause obstruction of discharge port, affecting the normal production. Cleavage developed a direct impact on the extent of the ore crusher productivity - due to ore crushing, easy to break along the cleavage plane, so crushing high productivity cleavage developed ore crusher crushing dense structure than the corresponding ore much more.

To Choose a Right Underground Mining Equipment

How to choose a suitable cone crusher To the inlet and discharge opening width of the cone crusher feed opening width B = (1.2 ~ 1.25) D, where D is the feed size, the beneficiation process may be. Discharge opening width depends on the desired particle size. Crushing cone crusher with screening due to have a check, so it's discharge opening width is equal to the desired product size. The broken by cone crusher discharge opening width e = dmax / Z, where dmax is the maximum size of products; Z is too large particle discharge coefficient, ore crushing hard when Z = 2.4; medium hard ore Z = 1.9 ; soft ore Z = 1.6 Nip angle in the actual design calculations, nip angle cone crusher is usually between 21 ° ~ 23 ° selection.