3P+NPE Surge Protectors

LYD1 Series Surge Protective Device (SPD)

3P+NPE Surge Protectors

LYD1 Series Surge Protective Device(SPD) is suitable used in the IT, TT, TN-C, TN-S, TN-C-S, and low-voltage up to 380V, to protect from direct and indirect lightning impulse and other transient over voltage. As per the conditions of IEC61643-1:1998-02 standard , class I surge protective device, it is category B surge protective device. SPD has two protection modes: MC and MD, SPD is in compliance with IEC61643-1 standard.

Technical Specifications:

Operation Elements:

1. SPD as only one side of terminals able to prevent from being electric touching, indoor fixedly mounted, limiting voltage.
2. SPD has built-in disconnector, when SPD is invalid due to overheating or break down, the disconnector can automatically separate SPD from the network, meanwhile send an indication signal. The visible window show white color in normal service, if to be separated from network, it will show red color.
3. Maximum discharge current of each wire: up to 100 Ka.

Installation:

1. To be mounted between LPZ0A or LPZ0B zone and LPZ1 zone, adopts 35mm standard mounting rail. The cross sectional area of multi-stand soft copper conductor: 6 to 35mm²
2. Generally it shall be mounted in the incoming side of main distribution panel or box.
3. Earthing wire shall be of 16 mm²dual color conductor, its length not more than 500mm.
4. In order to eliminate the influence on normal service of power network due SPD is invalid, it shall add fuse or breaker to be series connected in line(Note: selected according to standard current In)

Outside Size Fig.