RS 25W 24V 1.1A Single Output Switching Power Supply SMPS, power supplies for leds 24 st

MODEL

RS-25-24

OUTPUT

DC VOLTAGE

24V

RATED CURRENT

1.1A

CURRENT RANGE

0 ~ 1.1A

RATED POWER

26.4W

RIPPLE & NOISE (max.) Note.2

120mVp-p

VOLTAGE ADJ. RANGE

22 ~ 27.6V

VOLTAGE TOLERANCE Note.3

±1.0%

LINE REGULATION     Note.4

±0.5%

LOAD REGULATION    Note.5

±0.5%

SETUP, RISE TIME    

1800ms, 23ms/230VAC         4000ms, 30ms/115VAC at full load

HOLD UP TIME (Typ.)

80ms/230VAC   14ms/115VAC at full load

INPUT

VOLTAGE RANGE  

88 ~ 264VAC         125 ~ 373VDC (Withstand 300VAC surge for 5sec. Without damage)

FREQUENCY RANGE

47 ~ 63Hz

EFFICIENCY (Typ.)

86%

AC CURRENT (Typ.)

0.7A/115VAC         0.4A/230VAC

INRUSH CURRENT(Typ.)

COLD START 30A/230VAC

LEAKAGE CURRENT

<2mA / 240VAC

PROTECTION

OVER LOAD

110 ~ 180% rated output power

Protection type : Hiccup mode, recovers automatically after fault condition is removed

OVER VOLTAGE

27.6 ~ 32.4V

Protection type : Shut off o/p voltage, clamping by zener diode

ENVIRONMENT

WORKING TEMP.

-20 ~ +70°C (Refer to derating curve)

WORKING HUMIDITY

20 ~ 90% RH non-condensing

STORAGE TEMP., HUMIDITY

-40 ~ +85°C , 10 ~ 95% RH

TEMP. COEFFICIENT

±0.03%/°C (0~50°C)

VIBRATION

10 ~ 500Hz, 5G 10min./1cycle, 60min. each along X, Y, Z axes

SAFETY & EMC (Note 6)

SAFETY STANDARDS Note.6

UL60950-1, TUV EN60950-1 approved

WITHSTAND VOLTAGE

-I/P-O/P:3KVAC     I/P-FG:1.5KVAC     O/P-FG:0.5KVAC

ISOLATION RESISTANCE

I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25°C/ 70% RH

EMC EMISSION

Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3

EMC IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A

OTHERS

MTBF

309.7Khrs min. MIL-HDBK-217F (25°C )

DIMENSION

78*51*28mm (L*W*H)

PACKING

0.2Kg; 60pcs/13Kg/0.46CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation and load regulation.

4. Line regulation is measured from low line to high line at rated load.

5. Load regulation is measured from 0% to 100% rated load.

6. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.