20 Gallon Sand Blaster , High Quality Sand Blaster For Sale!

20 Gallon Sand Blaster  Model Nr.:SBA-20

Specification:
Has safety pressure release valve,3/8in.Brass valves for air throttling
and sand metering.
Work pressure:65 to 125PSI
Baked enamel finish.
Heavy duty3/8in,8-ft,hose has carbon steel shut off valve and 4 inter
changeable nozzles.
Hood and instruction are in stock;
Hose length: 10ft
Tank dimension: 12-1/2"dia,27"length
Pres sure gauge indicator: 0~125PSI
Required compressed air system(not includeb): 2HP compressor
with3/8" diameter air hose
Recommended media type: glass bead,silicon carbide,alumina,walnut
shell,brass bead
Recommended use: use with 80,100,120 grit media,at 60PSI,
with3/32".Nozzle for best results(run time;45minutes with 90lbs,media
Water trap type: push button to drain
Accessories:3/32"nozzle,

Package details:
Pcs/Ctn: 1
G.W./N.W.: 23/21kgs
Dimension: 84*35*45cm
Q‘TY/40' : 420pcs

WARNING: To reduce the risk of injury, always protect eyes and face with goggles and mask, and hands and arms with heavy work gloves when spraying abrasive materials.

Place the sand blaster induction probe in the sand supply container.

How To Sandblast :

1.    Connect and open the water supply line before starting the pressure washer.

2.    Trigger the gun to relieve the air in the equipment.

3.    Start the pressure washer. See its instruction manual.

4.    Trigger the gun to activate the spray.

CAUTION: Always test spray on a scrap of similar material first! The high pressure spray could damage the surface if the sandblaster is held too close. See step 5 below.

5.    To check the distance you will need to hold the spray nozzle from the surface, start to spray at the scrap of material from a distance of several feet. Gradually move closer, checking frequently to see if the high pressure spray is damaging the surface.

6.    See the application below for the type of sand recommended for your work surface.

Always point the nozzle downward when not spraying. This prevents water from entering the sand supply. If water does get into the sand supply hose, remove the probe from the sand, hold the gun trigger open, and let the hose air dry. Always be sure the sand hose is dry before using.

Keep the sand covered to prevent the overspray from wetting the sand. Do not allow small pieces of the sand bag to fall into the sand supply. A smaller piece could prevent the flow of sand.

Cnjacks' Sand Blaster Models Review

Cnjacks’ Sand Blaster Workshop View