Huawei AP6310SN-GN outdoor wireless access point huawei access point

  Huawei   AP6310SN-GN   Series wireless access point

  The AP6310SN-GN is an enhanced series indoor single-band Access Point (AP), which supports indoor distributed coverage. The AP6310SN-GN can be used together with the 2G/3G/CATV Signal System, and they share the 2G/3G/CATV indoor distributed system. The AP6310SN-GN is applicable to the indoor wide coverage scenario with signal attenuation and low user density.

  The AP6310SN-GN is recommended on large-scale networks where users are distributed in a large area and an indoor distribution system is used, for example, office buildings, business buildings, hotels, airports, and bus stations. The AP6310SN-GN APs provide indoor wireless signal coverage in these scenarios

WLAN features

• AP6310SN-GN: complies with IEEE 802.11b/g/n.
• AP6310SN-GN: provides a maximum rate of 150 Mbit/s.
• Maximum ratio combining (MRC)
• Maximum-likelihood detection (MLD)
• Data unit aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Rx only)
• Short GI in 20 MHz and 40 MHz modes
• Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to implement priority-based data processing and forwarding
• Automatic and manual rate adjustment (the rate is adjusted automatically by default)
• WLAN channel management and channel rate adjustment
• Automatic channel scanning and interference avoidance
• Service set identifier (SSID) hiding
• Signal sustain technology (SST)
• Unscheduled automatic power save delivery (U-APSD)
• Control and Provisioning of Wireless Access Points (CAPWAP) in Fit AP mode
• Automatic login in Fit AP mode

Network features

• Compliance with IEEE 802.3u
• Auto-negotiation of the rate and duplex mode and automatic switchover between the Media Dependent Interface (MDI) and Media Dependent Interface Crossover (MDI-X)
• SSID-based VLAN assignment
• VLAN trunk on uplink Ethernet ports
• 4094 VLAN IDs (1-4094) and a maximum of 16 virtual APs (VAPs) for each radio
• AP control channel in tagged and untagged mode
• DHCP client, obtaining IP addresses through DHCP
• Tunnel data forwarding and direct data forwarding
• STA isolation in the same VLAN
• Access control lists (ACLs)
• Link Layer Discovery Protocol (LLDP)
• Uninterrupted service forwarding upon CAPWAP channel disconnection in Fit AP mode
• Unified authentication on the AC in Fit AP mode
• AC dual-link backup and VRRP hot backup in Fit AP mode

Specifications

Radio Specifications