MCP Fire Pull Station Resetable Fire Manual Call Point Emergency Alarm Security System

Fire Pull Station Emergency Fire Call Point Resettable Fire Button Conventional Fire Alarm System. 2-wire non-polarized fire push button connects with any brand conventional fire alarm control panel, smoke detector, heat detector, gas sensor, siren strobe to complete fire alarm and fire fighting security system.

The conventional manual call point designed for conventional fire alarm system for reporting fire or emergency condition by its PUSH IN/PULL DOWN handle latches. One 470 ohm resistor is used on the PCB board between Zone+ and Zone- when the switch inside is closed. So the conventional manual call point is only used with conventional fire alarm control panel, it is forbidden to be used to other system.

Conventional Manual Call Point, Operates by Advanced MCU Expert Algorithm Software.

Fire alarm system category and installation instruction, datasheet, manual can be downloaded at fire alarm category

Technical Specifications

Ordering Information

Individual(1 units)

Dimensions

(w x d x h millimetres) Weight

140x105x45 220g

Dimension: 140mmX105mm

Height: 45 mm

Weight: 220 g

Operating Temperature Range: -10°C to 50°C

Operating Humidity Range: 10% to 93% Relative Humidity, Non condensing

Latching Alarm: Reset by momentary power interruption

Top Side

Figure 1. Dimension of manual call point:

Electrical Ratings

System Voltage (nominal): 24 VDC (9V~ 28VDC)

Standby Current: 60 μA @ 24VDC

Alarm Current: 10~30 mA @ 24VDC

call-point based upon our industry standard series housing, and features easy to install, push-fit wiring terminals.

The unit can support either a 'Frangible Glass' element or a 'Non Frangible Plastic' element.

Push in and Pull Down Call Point

Can be reset by key

Red colour

Fire proof materials

470 Ohm Resistance

Modern style Call Point