HC-S025 human body model Simple electronic semi-physical lung resuscitation simulator/half body cpr training manikin

with alarm warning light display error

Cardiopulmonary Resuscitation Simulator Cleaning Guide:
1. The simulated human skin and chest skin are made of the same material and can be cleaned by the same cleaning method.
2. If the item becomes dirty, please wash it with soapy water; if it is very dirty, use some household cleaning agents or detergent to clean it.
???Such as: oil gourd, detergent, etc. It is recommended to use the cleaning agent with the least abrasive product to ensure the skin life.
???The dough can be wiped with dilute alcohol to avoid disinfection (do not use corrosive liquid for soaking)
3. When using for teaching, you can use dilute alcohol to wipe and disinfect for additional safety measures. Don't forget to wipe the foam part of the upper chest with the same method.
???Keep the interior of the simulator clean.
?
Cardiopulmonary resuscitation simulator installation instructions:
1. Gently hook the buckle on the shoulder of the simulator to pull up and open the chest.
2. Connecting the head: Place the neck of the head part on the two main axes of the neck of the torso.
3. Folding the lung bag: There are 4 dotted lines on one side of the lung bag printed on an ellipse; the lung bag is folded into 4 folds along the dotted line.
4, lift the simulated chin, so that the head is uplifted;
5. Insert the folded lung bag from the mouth;
6. Continue to push the lung bag into the mouth until it comes out of the neck;
7. Pull out the extended one out;
8. Place the lung bag on top of the compression (ie, the plastic on the center of the foam portion of the torso) to match the ellipse on the lung bag to the plastic position on the torso;
9, please confirm that the lung bag has been flattened without twists and turns;
10. Fasten the mask to the buttons on both sides of the head;
11. At this point, the torso can be closed and the two buckles on the shoulders can be buckled.
?
About frequency detector and compression depth alarm:
The detector of this product has a unique function of detecting the depth and frequency of compression;
On the first press, the three lights on the left shoulder will all illuminate, indicating that the battery is fully charged and the three lights are working properly;
If the light is not lit when pressed, first check if the compression depth is sufficient (you will hear a click). The light will also not illuminate when you have not pressed it to the correct position.
If the pressing depth is correct and the light does not illuminate, replace the two alkaline batteries (inside the battery compartment behind the left shoulder of the simulator).
Once the chest is pressed, the amber light and the green light will be extinguished. If the pressure is pressed less than 80 times per minute, the red light will light up;
When you increase the compression frequency to 80 times per minute, the red light is on.
When you increase the compression frequency to 100 times per minute, the green light will illuminate, indicating that the appropriate compression frequency has been reached.
When you slow down the pressing speed, the green light will go out, indicating that you need to increase the pressing frequency.
If your compression depth is insufficient, a red light flashing alarm is displayed.

About artificial respiration:
Workers can see obvious chest undulations while breathing;

Standard configuration:
1. A half-body resuscitation simulator;
2. 10 disposable airways;
3. A manual for use;
4, certificate, warranty card