HC-R055E Portable pigs backfat meter pig farming fat scanner

- It is suitable for memorization of pigs, horses, cattle, sheep and other livestock.
- New probe production technology and digital algorithm upgrade.
- The use of pulsed ultrasound to measure the thickness of a mammal's backfat can detect three layers of backfat thickness.
- Measurement range: 4-35mm, accuracy ±1mm, test sensitivity: <50mv.
- This machine is equipped with a waterproof probe, which is highly accurate and durable

* the charger, the battery charging apparatus by electricity (about 12 hours before the first use), every after charging time is generally three times the time of use (for example, one hour charge three hours of electricity), so you can extend battery life. When the power is exhausted, the display will start flashing or remain in the shutdown state does not show.

*The most accurate back mapping points: can use finger palpable ribs, ventral from the front walk until you can feel the last rib, then put probe from the back left or right direction 6.5cm position, with a light thin oil coating through the measured parts, so that the probe has good contact. In order to make ultrasound into the pigs to be reflected back fat sensing device. The middle to press the power button on the measuring instrument, the probe placed in the measured parts, light pressure with rotary action for any extrusion between the probe and the skin of the bubble, measured in vertical downward direction, if oblique may cause the error value, the most easy operation method is to use the index finger and probe middle finger to hold the probe, when the value of light readable instructions, on the right side of the said measure readings. If the light does not show that may be skin bad, add some oil to the skin or between the probe and the bubble pressure in addition to, and to determine the probe is vertically down flat contact pig skin surface, consistent with the mode of operation is an important factor to make better measurements.

*The first test should take the number of switch in the "3", which will measure the total depth of third layers of back fat, red numbers will be displayed, when LEAN-MEATER found the back fat third layer, third layer if the back fat does not exist, the number is not displayed, then please turn off the instrument, set the number of switch to "2", and open the instrument, the red digital display when the LEAN-MEATER detect and measure second layer back fat total, LEAN-MEATER will be in a few seconds to measure several times, until the confirmation of new readings, irregular fat may sometimes obstruct the sound ray, caused by LEAN-MEATER are low readings, then slightly the mobile X-ray probe will bypass, can a correct reading display, (Note: you must always keep the probe in the animal's back), fat layer is not consistent thick Degree, therefore, can be measured in the adjacent range of three to two readings is the most insurance, but also to ensure the greatest accuracy. Boot when the data is not significant, only in the measurement of the display is a reference to the data. The accuracy of the reading is + 1mm, the available range is 5mm to 35mm