Module spare parts PXAH401 3BSE017235R1

Focus on DCS, PLC, robot control system and large servo system.

Main products: various modules / cards, controllers, touch screens, servo drivers.

Advantages: supply of imported original products, professional production parts,

Fast delivery, accurate delivery time,

The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands

Paint only clean, dry, absorbent surfaces. Remove dirt, oils, grease, wax, sanding dust, paint remover, etc. with PORTERPREP? Heavy Duty Cleaner No. PP571, Dirtex and water, Porter Paint Thinner No. 5132 or other appropriate cleaners, or by vacuuming as necessary. Remove mildew by washing with a commercial mildew remover such as X-14 Mildew Remover or a mix of 1 part chlorine bleach to 3 parts clean water (rinse thoroughly after 15 minutes). WARNING! If you scrape, sand, or remove old paint, you may release lead dust or fumes. LEAD IS TOXIC. EXPOSURE TO LEAD DUST OR FUMES CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a properly fitted NIOSH-approved respirator and prevent skin contact to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the USEPA National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. Follow these instructions to control exposure to other hazardous substances that may be released during surface preparation. NEW WOOD: Repair construction defects, sand as necessary. Fill openings and nail holes with a suitable filler if necessary and sand smooth. OLD WOOD: Remove old coatings and weathered wood by pressure washing, power tooling or hand scraping and sanding as necessary to achieve a sound, absorbent bare wood surface. Sand smooth if necessary. CONCRETE FLOORS: To achieve a uniform appearance, acid etch the floor with muriatic acid (see Porter Technical Bulletin #14, ACID ETCHING CONCRETE). For a dust seal on un-etched concrete, clean thoroughly and allow the concrete to fully dry. REAPPLICATION ON WORN OR WEATHERED SURFACES: Apply test patches in several locations to be sure that the surface is open and porous enough for reapplication. Proceed if the test material strikes into the surface