MITSUBISHI A1S61PN

Brand:MITSUBISHI

Type:A1S61PN

Origin:the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Module of PLC, DCS, ESD system card, the card is a vibration monitoring system, steam turbine control system module, the advantages of the gas generator spare parts brand: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts of our products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, mechanical, electronic manufacturing, automobile manufacturing, plastic machinery, electric power, water conservancy, water treatment/environmental protection, boiler heating, energy, power transmission and distribution and so on.

ADDITIONAL SAFETY PRECAUTIONS Motor Case Grounding Insure that the motor’s case is connected to PE ground. The fourth wire in the motor cable connecting J2-1 or TB1-1 to the motor case accomplishes this. CAUTION If the motor is not properly grounded, dangerous voltages can be present on the motor case due to capacitive coupling between the motor windings and case. Requirements for Safe Operation of the Drive It is the machine builder’s responsibility to insure that the complete machine complies with the Machine Directive (EN60204). The following requirements relate directly to the servo controller: 1. Emergency Stop CAUTION If personal injury can result from motor motion, the user must provide an external hardwired emergency stop circuit outside the drive. This circuit must simultaneously remove power from the drive’s motor power terminal J2-2, J2-3, and J2-4 or TB1-2, TB1-3, and TB1-4 and disable the drive (by open circuiting the connection to J4 pin 2). NOTE The motor will coast under this condition with no braking torque. CAUTION If braking torque is required to quickly stop the motor, a dynamic brake can be added that loads the motor’s windings resistively. The motor should not be loaded until the servo drive is disabled. The holding brake, optional on Danaher Motion motors, is not intended to stop a spinning motor. It is designed to prevent a stopped motor from rotating due to an applied torque. 2. Avoid Unexpected Motion CAUTION Always remove power from J1 or TB1, J1 and wait 5 minutes before working on the machine or working anywhere where injury can occur due to machine motion. 3. Avoid Electrical Shock CAUTION Never power the servo drive with the cover removed or with anything attached to circuitry inside the cover. If the drive must be removed from the cabinet, wait at least five minutes after turning off power before removing any cables from the drive or removing the drive from the mounting panel. Never connect or disconnect any wiring to the drive while power is applied. Always power down and wait five minutes before connecting or disconnecting any wires to the terminals. 4. Avoid Burns CAUTION The temperature of the drive’s heat sink and housing as well as an external regen resistor may exceed 60° C. Therefore, there is a danger of severe burns if these regions are touched. 5. Prevent Damage to the Drive Follow these guidelines to prevent damage to the servo drive during operation: Never plug or unplug connectors with power applied. Never connect or disconnect any wires to terminals with power applied. If the drive indicates a fault condition, find the cause of the fault and fix it prior to resetting the fault or power-cycling the drive.