Module spare parts WATLOW ANAFAZE CLS208

Focus on DCS, PLC, robot control system and large servo system.

Main products: various modules / cards, controllers, touch screens, servo drivers.

Advantages: supply of imported original products, professional production parts,

Fast delivery, accurate delivery time,

The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands

WATLOW ANAFAZE CLS208

The O2 and air supply connections are located on the back of the ventilator. The air supply connection is on the left side and the O2 supply connection is on the right side as labeled on the ventilator. The ventilator comes with a standard air pipeline inlet assembly which includes a filter bowl, o-ring, and filter element. The O2 pipeline inlet filter assembly can be ordered. See the "Parts and accessories" section for ordering information. Use only gas supply hoses that meet ISO 5359. Gas supply sources must contain a safety device which prevents supply pressure from exceeding 1000 kPa during a single fault failure of the gas supply system. Use only clean and dry medical oxygen and air supplies. 1. Connect the air supply connection to the back of the ventilator and tighten. 2. Connect the O2 supply connection to the back of the ventilator and tighten. AB.98.055 2 1 1. Air supply connection 2. O2 supply connection To disconnect the air or O2 gas supply connections: unscrew the hoses from the gas supply source, then unscrew the hoses and remove them from the back of the ventilator. WARNING ? CAUTION Note 4 Setup and connections 2065490-001 4-9 Connecting the exhalation valve heater Use the exhalation valve heater to prevent moisture from condensing in the expiratory flow sensor when a humidifier is used. Port 3 must only be used for connecting the exhalation valve heater cable. Order cable separately. See Exhalation valve heater in the "Parts and accessories" section for ordering information. 1. Attach and tighten the cable to Port 3 on the back of the ventilator. AB.98.314 2. Thread the cable through the rear channel to the front of the ventilator. AB.98.317 3. Angle the cover over the exhalation valve housing and gently press into place. CAUTION Important CARESCAPE? R860 4-10 2065490-001 AB.98.320 4. Align and match the red dots from the exhalation valve heater cable to the power cable and snap together. Connecting the cable will power on the exhalation valve heater. AB.98.321 To disconnect and remove the exhalation valve heater, follow instructions in reverse order.