Module spare parts ABB 3BHT100010R13BHT100018R1 RF615 RC610

Focus on DCS, PLC, robot control system and large servo system.

Main products: various modules / cards, controllers, touch screens, servo drivers.

Advantages: supply of imported original products, professional production parts,

Fast delivery, accurate delivery time,

The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands

ABB 3BHT100010R13BHT100018R1 RF615  RC610

Devices labeled with this symbol and the equipment described in this instruction require special handling precautions. This equipment contains components that can be damaged from discharges of static electricity; therefore, avoid contact with terminal block conductors and electronic components on the circuit boards. Ordinarily, components will not be damaged if circuit boards are handled by the edges. Refer to Electronic Industries Alliance (EIA) standard EIA-625, Requirements for Handling Electrostatic-Discharge-Sensitive (ESDS) Devices for detailed procedures on handling electronic components. This standard is the most comprehensive semiconductor ESD handling procedure in the industry. GENERAL WARNINGS Equipment Environment All components, whether in transportation, operation or storage, must be in a noncorrosive environment. Electrical Shock Hazard During Maintenance Disconnect power or take precautions to insure that contact with energized parts is avoided when servicing. SPECIFIC WARNINGS Use this equipment only in those classes of hazardous locations listed on the nameplate. Uses in other hazardous locations can lead to unsafe conditions that can injure personnel and damage equipment. (p. 3-2) All error conditions are considered catastrophic and require transmitter replacement. Replace the transmitter with a transmitter that is known to be operable. Leaving an inoperable transmitter in the process could cause process upsets. Some process upsets can lead to dangerous conditions that can harm personnel and damage equipment. (p. 12-6) Allow only qualified personnel (refer to INTENDED USER in Section 1) to commission, operate, service, or repair this equipment. Failure to follow the procedures described in this instruction or the instructions provided with related equipment can result in an unsafe condition that can injure personnel and damage equipment. (p. 13-1) WTPEEUI520002A1 x Safety Summary (continued) SPECIFIC WARNINGS (CONTINUED) Do not substitute any components other than those listed in the appropriate procedures. Doing so will compromise the certification listed on the transmitter nameplate. Invalidating these certifications can lead to unsafe conditions that can injure personnel and damage equipment. (p. 14-1) Do not disconnect equipment unless power has been switched off at the source or the area is known to be nonhazardous. Disconnecting equipment in a hazardous location with source power on can produce an ignition-capable arc that can injure personnel and damage equipment. (p. 14-1) Consider the material compatibility between cleaning fluids and process liquids. Incompatible fluids can react with each other causing injury to personnel and equipment damage. (p. PR27-1) Acids and bases can cause severe burns. Use hand and eye protection when handling. (p. PR27-1) Use solvents only in well ventilated areas. Avoid prolonged or repeated breathing of vapors or contact with skin. Solvents can cause nausea, dizziness, and skin irritation. In some cases, overexposure to solvents has caused nerve and brain damage. Solvents are flammable - do not use near extreme heat or open flame

.