BENTLY 3500/33 149986-01

Brand:BENTLY

Type:3500/-33 149986-01

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Spare parts spare parts, the main DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

CI873 and TP867 - EtherNet/IP Interface Key Features ? CEX-Bus Module. ? MPC862P 96MHz. ? 32 Mbps SDRAM with integrity check. ? 4 Mbps Flash PROM. ? Ethernet/IEEE 802.3u supporting full Fast Ethernet 10/100Mbps operation. ? Supports EtherNet/IP protocol. ? 10/100 Mbps use IEEE standard Media Independent Interface (MII) Description The CI873 can be used to connect an AC 800M controller to external Ethernet devices using the EtherNet/IP protocol. The TP867 Baseplate has two RJ45 Ethernet connectors. For CI873, only the CH1 connector that supports 10 Mbps/100 Mbps is used.The baseplate has a code lock which prevents the installation of an incorrect unit type onto the TP867 Baseplate. The CI873 expansion unit contains the CEX-Bus logic, a communication unit and a DC/DC converter that supplies appropriate voltages from the +24 V supply through the CEX-Bus. The Ethernet cable must be connected to the main network through an Ethernet Switch.

There are six LED indicators on the front panel of CI873 that indicate the various states and conditions on the CI873. Table 108. EtherNet/IP Interface CI873 - LED indicators Designation/Color Function F(ault) / Red The red F(ault) LED indicates a fault condition on CI873. Reset turns the LED ON. Software can turn it On and OFF through a register in the CEX-Bus controller. R(un) / Green The green R(un) LED indicates that the CI873 is operational. Reset turns the LED OFF. Software can turn the LED ON and OFF through a register in the CEX-Bus controller. RxTx1 / Yellow The yellow Rx/Tx1 LED is intended to be ON to indicate a receiving/transmitting telegram at CH1. The LED is controlled by Ethernet PHY. It is turned OFF by reset. RxTx2 / Yellow The yellow Rx/Tx2 LED (LED will always be switched OFF) is intended to be ON to indicate a receiving/transmitting telegram at CH2 (The channel is disabled). The LED is controlled by Ethernet PHY. It is turned OFF by reset. PRIM(ary) This LED is ON if this CI873 acts as the primary in a redundant configuration. DUAL The yellow DUAL LED is ON when both CI873’s in a redundant pair are synchronized. The LED is controlled by software. It is turned OFF by reset.