PFTL101B?20KN?3BSE004203R1 ABB Spare parts of tension controller are supplied from stock

PFTL101B 20KN 3BSE004203R1 ABB Spare parts of tension controller are supplied from stock

PFTL101B 20KN 3BSE004203R1 ABB Spare parts of tension controller are supplied from stock

The information in this document is subject to change without notice and should not be construed as a commitment by ABB AB. ABB AB assumes no responsibility for any errors that may appear in this document. In no event shall ABB AB be liable for direct, indirect, special, incidental or consequential damages of any nature or kind arising from the use of this document, nor shall ABB AB be liable for incidental or consequential damages arising from use of any software or hardware described in this document. This document and parts thereof must not be reproduced or copied without ABB AB’s written permission, and the contents thereof must not be imparted to a third party nor be used for any unauthorized purpose. The software described in this document is furnished under a license and may be used, copied, or disclosed only in accordance with the terms of such license

This manual describes load cells PFTL 101A, PFTL 101AE, PFTL 101AER, PFTL 101B, PFTL 101BE and PFTL 101BER in a Pressductor? Tension Measuring System. The purpose of this manual is to describe the general function and design of the load cells and also to be a guidance at installation, commissioning, preventive maintenance and fault tracing.

Our Email: 2235954483@qq.com

contact number:13313705507

contacts：HE

The load cells in the PFTL 101 family are available in six different measuring ranges from 0.5 to 20 kN and two different sizes (see 2.2 Technical Data). Each load cell is individually calibrated and temperature compensated. The load cells are usually mounted and fixed to a base and a bearing housing with six screws, four on one side of the load cells and two on the opposite side. For all load cells of type PFTL 101 the load cell house is machined from a single block of steel. A sensor is then welded into the load cell house and oriented so that it is sensitive to force in the direction of measurement and insensitive in other directions. The load cell types PFTL 101A, PFTL 101AE, PFTL 101B and PFTL 101BE are made of stainless steel. PFTL 101A and PFTL 101B are equipped with a connector for the pluggable connection cable. PFTL 101AE and PFTL 101BE are equipped with a fixed connection cable. Load cell types PFTL 101AER and PFTL 101BER are specially designed for installation in corrosive environment. They are made of acid resistant stainless steel and they also have a fixed connection cable.