Air water heating 12V 5kw integrated parking heater

The heating system uses diesel or gas as fuel. After heating the cooling liquid of the engine, the forced-circulation water pump circulate in the car's water way, preheats the engine and reduces the attrition, achieves the purpose of eliminating the frost and warming the compartment.

Preface:

The integrated machine is only used for heating and cold-heating of the engine in the car. It is not responsible for the heating of the fuel tank. It should be installed in parallel with the warm air, and take a small cycle. The car must be equipped with qualified sections. The temperature device (installation method and 220v preheater phase), the machine inlet and outlet water pipe clamps should be tight and tight, the water pipe can not be close to the exhaust pipe to avoid burns, the water inlet and the water outlet must be equipped with a high temperature resistant pipe joint and then connected with other ordinary water pipes.



The water pump should be 20 cm lower than the water tank. After the integrated machine is exhausted, the air-heat switch should be opened together with the water pump switch. When the water temperature reaches 0-30 degrees, the vehicle can be started. After the vehicle is started, the water pump can be turned off. It is especially suitable for four-cylinder machines such as pickup trucks, vans, motor homes, and agricultural vehicles.

※(Large trucks, engineering machinery vehicles, etc. Six cylinders -30 °C must be pre-heated for more than 60 minutes to achieve the normal starting temperature, this machine can only reach 4 kW 220v electric preheating effect, please understand if the expected value is too high).Three packs of accessories, the whole machine is not returned.

5 star review of our heater :