Home
Product Categories

CNG LPG completed kits

ECU kits

Emulator kits

Explosive products

Injector rail

New product

Other products

Reducer

Switch kits

Timing advancer

Ungrouped
Company Profile

Company Introduction

Photo Gallery
Blog
Quality Control
Contact Us

Home > Products > Explosive products > hot selling efi conversion kits1000cc motorcycle engine cng efi carburetor

hot selling efi conversion kits1000cc motorcycle engine cng efi carburetor

FOB Price

Negotiable

1 (Min. Order)

Payment TermsT/T Credit Card

Request Sample Customized Request Request Free Catalogs

Contact Now

Get lowest price

Product Description

Products Description

hot selling efi conversion kits1000cc motorcycle engine cng efi carburetor

Natural Gas for Vehicles (NGV) is a fuel for internal combustion engines that is basically composed of Methane gas and its use offers extraordinary advantages.

NGV, unlike gasoline, does not contain lead because of its high octane rating (120-130). As combustion is more complete, the contaminating effects of the exhaust gas emissions are reduced by approximately 80%. These gases are also less corrosive, thus increasing the duration of the exhaust system. NGV keeps the spark plugs clean, prolonging their use; it does not contaminate the oil, doubling the time required for oil changes and that of the filters; it improves lubrication because the cylinders are not washed by gasoline excess, thus avoiding premature wear in the motor.

In today’s world there are constant advances in all aspects that concern security in case of automobile accidents; in gasoline vehicles the fuel is transported in thin sheet metal tanks that are very fragile when impacted and can explode. CNG is stored in steel cylinders with 6 to 8 mm thick walls; this literally makes it the most resistant component of the vehicle. The steel fuel pipes are also more resistant than the gasoline ones; even if there were to be an accidental breakage or leak, instead of the dangerous gasoline spill on the ground underneath the vehicle, the very light NGV will rise rapidly and dissipate into the air.

Component :

The installation of the gas equipment comprises the following parts:

Product Name	Recommended Products
1. CNG carburetor reducer-180kw	ACT-98 reducer
2. Oil shutoff valve	Oil shutoff valve
3. Mixer	#58/#63/#65/#68/#74/#78/#82 Mixer
4. Manometer	CB08/201C Maometer (5V or 12V)
5. Filling Vavle	QF-T1H6/CTF-10/T2H/T2H-1/QF-T1H9/QF-T3H/ TES filling vavle
6. Switch kits	AS816/ ACT 722/ACT-EFC switch
7. High pressure tube	6m*6mm carbon steel/copper/stainless steel high pressure tube
8. Cylinder tank	30-40-60-90-120 L CNG cylinder tank
9. Rubber cap and belt	Common rubber cap and 2. 5M belt
10. CNG Casing	Water pipe 7. 5141500mm Bellows 34.5650mm Single point trachea 1927*800mm
11. Accessories bags	CNG single point accessories bags

Notice :

There are a few checks that need to be performed before the vehicle enters the installation workshop for conversion, to determine whether it is suitable for installation of the NGV equipment.

The structure of the vehicle must be inspected, to check if it is in a good state that allows adequate fitting of the supports of the various elements such as the NGV tank (s), the pressure regulator, the high-pressure pipe clamps, etc.

To make sure that the motor functions properly, check the following:

The ignition system: spark plugs, spark plug cables, contact points, condenser, ignition coil, ignition plate and distributor. The faulty state of any of these parts will cause a poor ignition spark, thus hindering the good functioning of the equipment.

The battery must provide 12 volts of power to the pressure regulator so that its electrovalve will open properly when the vehicle is operating on gas. The engine’s carburetion system must also work properly because even though a NGV system is being installed, the vehicle must be capable to operate in bi-fuel mode (gasoline/gas).

If the vehicle is not in good condition, the installation of the NGV system will not result in a satisfactory operation vehicle.

Contact Us

Chengdu ACT Technology Co., Ltd.

*Email
Please enter Your valid email address.
*To

Chengdu ACT Technology Co., Ltd.
*Message
Your inquiry content must be between 20 to 5000 characters.
Please enter a correct verification code.

Product Categories

CNG LPG completed kits	ECU kits	Emulator kits	Explosive products
Injector rail	New product	Other products	Reducer
Switch kits	Timing advancer	Ungrouped

hot selling efi conversion kits1000cc motorcycle engine cng efi carburetor

You May Like

Product Description

Component :

Notice :

Contact Us

Product Categories

New Products

Popular Searches

Recommended Products

Find Similar Products By Category