Constant temperature incubator plant insect culture laboratory equipment supplier Kenton manufacturers direct

Constant temperature incubator plant insect culture laboratory equipment supplier

Actual temperature detected from the sensor, transferred into signal and transmitted through microcomputer control. And the signal is sent to the heater. The heater element will heat up towards required temperature.

When temperature control is not ideal, You can use PID. During PID setting, temperature can fluctuate, please consider it as a factor towards end result.

In non-setting mode, press “shift” for 6 sec. to enter PID mode. “AT” indicator light flashes, the indicator light stops flashing when it finishes. The control system will obtain new set value of PID parameter, then auto-save the data. During auto-setting, long press “shift/self-tuning” button for 6 seconds to stop.

During self-tuning, if there’s over-heating, “ALM” indicator light is on, heating alarm relay will automatically detach, but beeper will not beep. During auto-setting, “set” button is unavailable. No matter whether there is setting for temperature control timing. Lower screen of the control panel will always display set temperature during auto-setting.

1.Temp control range :+5～65℃;

2.Temp. resolution: 0.1℃

3.Temp fluctuation range :±0.5℃(+3℃～50℃);

4.Temp uniform range :≤±1.0℃(+3℃～50℃ );

5.Power voltage : AC 220V/50Hz;

6.Timing range: 0~99hour, 0~9999min

7.Equipment class:class I

8.Working ambient :Ambient temp 10~40℃   Relative humidity70% below ;

Thermostatic Incubator:

/Thermostatic-incubator/20170526/3.html