Multi-Functional Q-Switch YAG Laser Beauty Machine For Tattoo and Freckle Removal

I. Machine structure

The Nd:YAG Laser Tattoo Removal System is made up of light route system, power supply system, computer controlling system, cooling system, etc. The light route system is installed into the hand piece, but power supply, controlling and cooling system are installed into the machine box of power supply.  

Main technical parameters:

Laser model:Q-switched Nd:YAG Laser  

Laser wavelength:1064/532 nm              

Pulse energy: 50mj

Pulse width:8ns

Repetition frequency:1, 2, 3,4,5, 6,7,8,9,10Hz

Cooling method:inner circulation water cooling

Power supply:AC110V± 10%, 50~60Hz; 230V±10%, 50~60Hz  

Main physical parameters:

Dimensions:500×600×1250mm3

Total weight:18kg

Each part’s name and function:

1. Emergency switch:When accident happened suddenly, press the red knob swiftly, then the machine is out of power. Turn the button in the arrow direction to spring it up and power resumes again.

2. Key switch:This is the main power supply switch. The screen displays a long horizontal line. Press the “down” button to shut down the signaling voice.

3. Simm (simmer):Pressing the knob makes system enter into the standby state.

4. Freq (frequency adjusting ) key:Set repeated frequency 1~6Hz.

5. Power (power adjusting) key:This is the keys that can adjust energy higher and lower. During operation, every time when “+” is pressed, its energy will increase by 20mj. Every time when “-” is pressed, its energy will decrease by 20mj.

 II.Working condition

Normal working condition:

1. Temperature:5°C-30°C

2. Relative humidity:≤70%

3. Pressure:860-1060hPa

4. Power supply:AC110V± 10%, 50~60Hz; 230V±10%, 50~60Hz

Working mode:interval and continuous working mode. Best to pause for 5 minutes after each continuous outputting of 5000 pulses.

Cooling:Circulatory water cooling with distilled water

III.Power supply

 Power supply:AC AC110V± 10%, 50~60Hz; 230V±10%, 50~60Hz  

 Connection: 1. Safety fuse socket: The safety fuse is installed into the power supply socket, using safety fuse(6A/ ¢5 ×20) which is used for over loading protection.  

 2. Power input socket: The machine should be connected to a power supply using a power cord.