Disposable Dust-proof Face Mask Medical Filter Non Woven Protective Medical Face Mask

Product Specification

Scope of Application: It is intended for use by clinical personnel during non-invasive procedures and covers the mouth, nose, and jaw of the user. 

strong>Condition of Storage and Transportation : Well-ventilated and Non-corrosive Storage. Protection from moisture and sunlight during transportation.

How to wear a facemask

1. First unroll the mask. Before wearing a surgical mask, wash your hands. Then unroll the mask. Stretch the crease in the center of the mask to open before you can put it on.

2. Put a rope over your ear, stretch the mask properly, put another rope over your ear, put a rope over your ear while wearing it, stretch the mask properly, t exert too much force, then place a rope over the other ear.

3. Press lightly on the bridge of the nose to close the mask. The metal strip above the mask needs to be pressed gently. Slide it to the sides to close the mask to the face.

How to clean a facemask?

You can rub the mask gently with soap, detergent, etc. Rub the dusty areas well. If the force is too strong, the fabric of the mask will become loose and reduce the dustproof function. So don't use too much force.

After washing with soap, the mask is then rinsed. Rinse the soap and washing powder on the mask.

The mask should be cleaned with soap or detergent and then boiled or scalded for disinfection.

After washing it, let it dry in a sunny and well-ventilated place. It must be well exposed to the sun, so that it can better disinfect and remove bacteria.

Where to buy Medical Surgical Face Mask

Chengdu Yidong Huiyun Science and Technology Co. , Ltd. to create a complete health industry ecological chain from the selection and control of Medicinal Materials, R & D and Production, prevention and health care to seeking medical treatment and seeking medical treatment, cover multi-category product development, rare medicinal materials selection, physical and mental health management, chain pharmacy expansion and other projects.

Production Environment: In compliance with GMP D class clean production workshop, the staff all wear masks, gloves and gloves for operation; workshop temperature and humidity testing, at any time for disinfection work.

How to make a facemask

1. Cut the non-woven fabric according to the size, with two layers of gauze (slightly smaller than the upper and lower edges of the non-woven fabric by 1cm, and the left and right sides are the same as the non-woven fabric);

2. Fold the upper edge of the non-woven fabric into the gauze suture, and the lower edge into the gauze suture (the direction of folding is the same side);

3. Tuck the left and right sides separately below 4cm, each 2cm fold, a total of 3 pleats, the direction of the pleats is the same downward, and the bottom of the mask is about 3cm from the last fold;

4. Sewing the two cotton cloth strips separately. The length of the white band on the upper end of the mask should be slightly longer than the lower end, because the upper end needs to be tied to the top of the head and the lower end to the neck;

5. Finally, cut off the excess thread;

6. The final mask shape: the upper and lower edges are 18cm long, and the two sides are 9cm wide.

7. Sterilize the prepared mask.

.