0.8-3.2 mm V-CUT aluminum plate,V-CUT Cutting Machine

V-CUT Cutting Machine Operating instructions：

Specification :

Product Name: PCB board v groove machine (5 pairs of plastic shaft)

Cutting width: 75mm wide vertical 380MM

Thickness: 0.8-3.2 mm

Cardboard each time V≥10 pit (above and below 10 knives)

Aluminum plate each time V≥ 5 pit (4 knife up and down)

PCB Board each time V≥ 8 pit (upper and lower knives 8)

Speed: 8 m / min

Spindle motor: 3KW inverter 3.7KW plastic shaft motor 120W close crate motor 60W

Mechanical Dimensions: 1200 mm x 980 mm x 1400 mm (W x D x H)

Weight: 145KG

Accessories: gasket set, V-CUT knife 4. Shield bearing 10, each the size of a wrench, a hex key set,

installed a turret.

Feature :

1, V-CUT aluminum shaft conveyor transport speed is adjusted to between 20 and 30, the transfer speed

of the thicker plate thinner slower speed can be adjusted faster board, under normal circumstances, the thickness was adjusted to 1.6 by 25 speed.

2, V-CUT aluminum plate conveyor speed adjustment knife arbor fastest speed, can slow the speed

V-CUT ordinary board.

3, V-CUT too ordinary board after V-CUT knife can not be used for V-CUT aluminum plate, V-CUT

aluminum plate with rough edges after the V-CUT knife can also be used for V-CUT ordinary board.

4, V-CUT aluminum plate must be cooled with alcohol, can not participate in water or water cooling.

Works Steps

1. V-CUT machine will be around and above the security guards to open the shell cover.

2. Then adjust the depth screw loosening and disassemble.

3. Taoban disassembly of the spindle drive into the middle of the wheel spindle and the spindle bearing

and relax around the upper and lower knife adjusting screw symmetry .

4. Hands hold the spindle vertically upwards heart heart out at the same time, the main axis, the knife

used (3,4) method, will be removed under the spindle.

5. Gasket fixed to the right side of the main axis of the screws removed.

6. 80-100MM first set of gauge pads into the axis, upper and lower knife shaft to the average of the

gasket.

7. Loaded blade in accordance with the requirements of MI size and installed the tool, in the loaded knife

blade when you should pay attention to the direction; the knife blade sharp outward-axis, the knife

blade tip inward axis.

8. Gasket fixed to the spindle to tighten the nut so that the blade can not be loose, and placed on the

bearing sets.

9. By (1,2,3,4) loaded action of the anti-V-CUT machine, good upper and lower knife, and a fixed screw.

V-CUT Board

1. By cutting threads tuned adjustment method of the V-CUT board. And screw fixed.

Cut Blades and shield bearing mounting method：

1. If the only knife, then knife the two bearing plates care must be to ensure that the average pressure of

the entire board.

2 . Such as twice or more, if the secant from the edge of more than 10mm, while the outer knife bearing

plate to be care. In contrast to the knife inside of the plate bearing care.

3. If the cutter is too wide the distance between the knife and the knife has to care between the bearing

plate.