PV Module withstand pressure ability testing machine / Solar panel deformation measurement testing equipment

PV Module withstand pressure ability testing machine / Solar panel deformation measurement testing equipment

Testing standard

It's conform IEC61215-2:2016 & IEC61730-2:2016 testing standard 

Purpose

This test is to determine the ability of the module to withstand wind , snow , static or ice loads

The Technical Specifications 

Our testing Machine's advantage :

1. Dynamic and Static integration

2.Static model: the positive load can arrived to +10000 pa, the reverse load can arrived to -6000pa ( we are  leader of the pv module fileds)

3.Software operation and control : Flexible operation

Testing Procedure

1.Equip the module so that the electrical continuity of the internal circuit can be monitored continuously during the test

2.Mount the module on a rigid structure using the method prescribed by the manufacturer including the mounting means (clips/clamps and any kind of fastener) and underlying support rails, if t here are different possibilities each mounting method needs to be evaluated separately , for all mounting methods , mount the module in a manner where the distance between fixing points is worst case, which is typically at the maximum distance. 3.On the front surface , gradually and uniformly apply the test load, load uniformity needs to be better than ±5% across the module with respect to the test load, maintain his load for 1h

4.Apply the same procedure as in step c to check back surface of the module or as uplift load to the front surface

5.Repeat step c and d for a total of three cycles