aluminum box +carton box

Glow Wire Test Apparatus IEC 60695-2-10 U Shaped Glow Wire Loop, Glow Wire Loop

Specification:

1,Glow-wire material: Nickel/Chromium (>77%Ni/20±1%Cr)

2, Diameter: 4,0 mm ± 0,07 mm (before bending)

3, Dimension A: (after bending) see 5.1

Characteristics of Resistance:

Appliance:

The tip of the glow-wire is then brought smoothly into contact with the test specimen for a duration of 30 s ± 1 s. An approximate rate of approach and withdrawal of 10 mm/s to 25 mm/s has been found to be satisfactory. However, the rate of approach shall be reduced to near zero upon contact to avoid impact forces exceeding 1,05 N. In those cases where the material melts away from the glow-wire, the glow-wire shall not be kept in contact with the test specimen. Following the application time, the glow-wire and the test specimen are slowly separated, avoiding any further heating of the test specimen and any movement of air which might affect the result of the test. The penetration of the tip of the glow-wire into and through the test specimen shall be limited to 7 mm ± 0,5 mm.

When forming the glow-wire , care shall be taken to avoid fine cracking at the tip.

 NOTE:

 Annealing is a suitable process for prevention of fine cracking at the tip.

Company Profile

Shenzhen Bonad Instrument Co., Ltd.

 14 Stanards drafted and issued by Labthink  -- 100 Patents granted by Labthink -- 410 m2 Laboratory to provide testing services  -- 20 years experienced lab technicians to provide solutions -- 12 months warranty  -- Remote Services (Free of Charge allthrough lifetime)

View more

Contact Us

Shenzhen Bonad Instrument Co., Ltd.

• *Email
  Please enter Your valid email address.
• *To

  

  Shenzhen Bonad Instrument Co., Ltd.
• *Message
  Your inquiry content must be between 20 to 5000 characters.
•  

  Please enter a correct verification code.

Send Now