Closed-top Plastic Drum/barrel 200L

Closed-top plastic drum/barrel 200L

white plastic drum Advantages

（1）Complete qualifications and trustworthy;

（2）Exquisite workmanship: Advanced one-piece molding technology ensures product toughness;

（3）Quality assurance: Strict process control to ensure the product's acid and alkali resistance and drop and compression resistance;

（4）Strict material selection: Strictly control the quality of raw materials, use food-grade HDPE, and add no harmful substances;

（5）Reasonable distribution of wall thickness;

（6）The drum mouth is smooth and the workmanship is meticulous;

（7）Clean production environment reflects our professionalism;

（8）High-quality and experienced R&D team;

（9）Complete quality control and testing system.

60l plastic drum Product Instructions

1. Unfilled liquids shall be tested for at least 6 months.

2. Do not contain substances that react with the drum or severely weaken the drum.

3. The temperature of filling liquid should not be higher than 60℃. The screw lid shall be screwed after filling liquid is cooled to normal temperature, with a torque of 25N ? m ~ 30N ? m being appropriate.

4. Before tightening the lid, check whether the sealing ring is installed in place and whether it falls off. When screwing the lid, aim at thread teeth to avoid leakage at drum mouth caused by slipping thread after wrong thread.

5. Liquid containing gas should adopt a closed lid of exhaust and tighten as required.

6. When the drum is filled with liquid, there must be enough space capacity.

7. When stacking czplasticfactory square plastic drum, the internal liquid should be cooled to room temperature before proceeding stack.

8. Avoid dropping during transportation and use, and avoid collision with hard sharp objects.

9. Drums should be stored in a clean, dry, well-ventilated, flat floor warehouse, and the storage temperature of the drums is ≤40℃.

10. The storage life of the drum is 2 years from the production date.

11. The inner container should be packed in a suitable outer packaging. The outer packaging must not have any protruding parts that will scratch the inner container.

12. Stacking and storage

(1) The drums packed with goods shall be stacked with double-sided flat pallets, with the pallet size no more than 1.3m. Each pallet shall be stacked with a maximum of one layer, and the number of stacked drums depends on the pallet size. The edge of the drum shall not exceed the edge of the pallet. The drums on the pallet shall be stacked symmetrically, so that the center of gravity of the whole pallet and its upper drum is located in the center of the pallet.

(2) The drums stacked on the pallets shall be packed and fixed with winding film. During packing, the closed head plastic drums should avoid squeezing or deformed with the deformation below 3%. After packing, the number of stacking layers of the pallets shall not exceed 2. When stacking, the upper and lower layers shall be aligned so that the weight of the upper layer is evenly applied to the lower layer. The ground of the stacking place shall be flat and in a horizontal position.

13. Loading and transportation

For long-distance transportation while loading dangerous articles:

(1) Pallets shall be used for stacking, and the size of pallets shall not be more than 1.3m, while the edge of drums shall not exceed the edge of pallets.

The receptacles shall be loaded into container or vehicle. The upper and lower layers shall be aligned during stacking to prevent stacking from skewing and instability. The industrial plastic container or vehicle shall have a rigid enclosure and fence at least the same height as the container to prevent the drum from tipping.